Datasheet

Safety data sheet according to Regulation (EC) No 1907/2006, Annex II
Revision date / version: 07.03.2017 / 0005
Replacing version dated / version: 28.02.2017 / 0004
Valid from: 07.03.2017
PDF print date: 09.03.2017
WD-40® MULTI-USE PRODUCT - [Aerosol]
8.2.2 Individual protection measures, such as personal protective equipment
General hygiene measures for the handling of chemicals are applicable.
Wash hands before breaks and at end of work.
Keep away from food, drink and animal feedingstuffs.
Remove contaminated clothing and protective equipment before entering areas in which food is consumed.
Eye/face protection:
Tight fitting protective goggles with side protection (EN 166).
Skin protection - Hand protection:
Protective nitrile gloves (EN 374)
Minimum layer thickness in mm:
>= 0,4
Permeation time (penetration time) in minutes:
>= 480
The breakthrough times determined in accordance with EN 374 Part 3 were not obtained under practical conditions.
The recommended maximum wearing time is 50% of breakthrough time.
Protective hand cream recommended.
Skin protection - Other:
Protective working garments (e.g. safety shoes EN ISO 20345, long-sleeved protective working garments).
Respiratory protection:
Normally not necessary.
If OES or MEL is exceeded.
Filter A P3 (EN 14387), code colour brown, white
Observe wearing time limitations for respiratory protection equipment.
Thermal hazards:
Not applicable
Additional information on hand protection - No tests have been performed.
In the case of mixtures, the selection has been made according to the knowledge available and the information about the contents.
Selection of materials derived from glove manufacturer's indications.
Final selection of glove material must be made taking the breakthrough times, permeation rates and degradation into account.
Selection of a suitable glove depends not only on the material but also on other quality characteristics and varies from manufacturer
to manufacturer.
In the case of mixtures, the resistance of glove materials cannot be predicted and must therefore be tested before use.
The exact breakthrough time of the glove material can be requested from the protective glove manufacturer and must be observed.
8.2.3 Environmental exposure controls
No information available at present.
SECTION 9: Physical and chemical properties
9.1 Information on basic physical and chemical properties
Physical state: Aerosol. Active substance: liquid.
Colour: Light brown
Odour: Characteristic
Odour threshold: Not determined
pH-value: n.a.
Melting point/freezing point: <-66 °C (ASTM D 97, Liquid concentrate )
Initial boiling point and boiling range: 176 °C (Liquid concentrate )
Flash point: 47 °C (Liquid concentrate )
Flash point: Enclosed space ignition test (UN RTDG, Manual of Tests and
Criteria, Part III, 31.5): <= 300 g/m3 (deflagration density)
Flash point: Enclosed space ignition test (UN RTDG, Manual of Tests and
Criteria, Part III, 31.5): <= 300 s/m3 (time equivalent)
Flash point: Ignition distance test (UN RTDG, Manual of Tests and Criteria,
Part III, 31.4): >= 75 cm
Evaporation rate: Not determined
Flammability (solid, gas): Yes
Lower explosive limit: 0,6 Vol-% ((Particulars of main substances contained) )
Upper explosive limit: 8,0 Vol-% ((Particulars of main substances contained) )
Vapour pressure: 7,2 bar (20°C)
Vapour pressure: 9,4 bar (50°C)
Page 7 of 14