SDS

Page 3 of 5
7 – Handling and Storage
Precautions for Safe Handling: Avoid contact with eyes. Avoid prolonged contact with skin. Avoid breathing
vapors or aerosols. Use with adequate ventilation. Keep away from heat, sparks, hot surfaces and open
flames. Wash thoroughly with soap and water after handling. Keep containers closed when not in use. Keep
out of the reach of children.
Conditions for Safe Storage: Store in a cool, well-ventilated area, away from incompatible materials. NFPA
30 Class II Liquid.
8 – Exposure Controls/Personal Protection
Chemical
Occupational Exposure Limits
LVP Aliphatic Hydrocarbon
1200 mg/m3 TWA (manufacturer recommended)
Petroleum Base Oil
5 mg/m3 TWA (Inhalable) ACGIH TLV (as Mineral oil)
5 mg/m3 TWA OSHA PEL (as Oil mist, mineral)
Aliphatic Hydrocarbon
1200 mg/m3 TWA (manufacturer recommended)
The Following Controls are Recommended for Normal Consumer Use of this Product
Engineering Controls: Use in a well-ventilated area.
Personal Protection:
Eye Protection: Avoid eye contact. Safety glasses or goggles recommended.
Skin Protection: Avoid prolonged skin contact. Chemical resistant gloves recommended for operations
where skin contact is likely.
Respiratory Protection: None needed for normal use with adequate ventilation.
For Bulk Processing or Workplace Use the Following Controls are Recommended
Engineering Controls: Use adequate general and local exhaust ventilation to maintain exposure levels
below that occupational exposure limits.
Personal Protection:
Eye Protection: Safety goggles recommended where eye contact is possible.
Skin Protection: Wear chemical resistant gloves.
Respiratory Protection: None required if ventilation is adequate. If the occupational exposure limits are
exceeded, wear a NIOSH approved respirator. Respirator selection and use should be based on contaminant
type, form and concentration. Follow OSHA 1910.134, ANSI Z88.2 and good Industrial Hygiene practice.
Work/Hygiene Practices: Wash with soap and water after handling.
9 – Physical and Chemical Properties
Appearance:
Light amber liquid
Flammable Limits:
(Solvent Portion)
LEL: 0.8% UEL: 5.6%
Odor:
Mild petroleum odor
Vapor Pressure:
1 psi @38C (100F)
ASTM D323
Odor Threshold:
Not established
Vapor Density:
Greater than 1 (air=1)
pH:
Not Applicable
Relative Density:
0.8 – 0.82 @ 60F
Melting/Freezing Point:
Not established
Solubilities:
Insoluble in water
Boiling Point/Range:
322 - 388F (161 -
198°C)
Partition Coefficient; n-
octanol/water:
Not established
Flash Point:
138F (59°C) Tag
Closed Cup
Autoignition
Temperature:
Not established
Evaporation Rate:
Not established
Decomposition
Temperature:
Not established
Flammability (solid, gas):
Not Applicable
Viscosity:
2.79-2.96 cSt @
100F
VOC:
24.9% MIR=0.44
gO3/gVOC (204
grams/liter)
Pour Point:
-63C (-81.4F ) ASTM
D-97