SDS

Page 3 of 5
8 – Exposure Controls/Personal Protection
Chemical
Occupational Exposure Limits
Petroleum Distillates
5 mg/m3 TWA ACGIH TLV (as Mineral oil)
5 mg/m3 TWA OSHA PEL (as oil mist, mineral)
Calcium Metaborate
None Established
Calcium
Dodecylbenzenesulfonate
None Established
Additive
None Established
The Following Controls are Recommended for Normal Consumer Use of this Product
Engineering Controls: Use in a well-ventilated area.
Personal Protection:
Eye Protection: Avoid eye contact.
Skin Protection: Avoid prolonged skin contact. Wash hands with soap and water after use.
Respiratory Protection: None needed for normal use with adequate ventilation.
For Bulk Processing or Workplace Use the Following Controls are Recommended
Engineering Controls: Use adequate general and local exhaust ventilation to maintain exposure levels
below that occupational exposure limits.
Personal Protection:
Eye Protection: Safety goggles recommended where eye contact is possible.
Skin Protection: Wear chemical resistant gloves.
Respiratory Protection: None required if ventilation is adequate. If the occupational exposure limits are
exceeded, wear a NIOSH approved respirator. Respirator selection and use should be based on contaminant
type, form and concentration. Follow OSHA 1910.134, ANSI Z88.2 and good Industrial Hygiene practice.
Work/Hygiene Practices: Wash with soap and water after handling.
9 – Physical and Chemical Properties
Appearance:
Blue colored grease
Flammable Limits:
Not established
Odor:
Pleasant odor
Vapor Pressure:
Not established
Odor Threshold:
Not established
Vapor Density:
Not established
pH:
Not Applicable
Relative Density:
0.9 g/cm3
Melting/Freezing Point
Not established
Solubilities:
Insoluble in water
Boiling Point/Range:
>316°C (>600°F)
Partition Coefficient; n-
octanol/water:
Not established
Flash Point:
>180°C (>356°F)
Autoignition
Temperature:
Not established
Evaporation Rate:
Not established
Decomposition
Temperature:
Not established
Flammability (solid, gas)
Not applicable
Viscosity:
>21 cSt (>0.21 mm2/s)
@ 40°C (104°F)
VOC:
Not established
Pour Point:
Not Determined
10 – Stability and Reactivity
Reactivity: Not reactive under normal conditions
Chemical Stability: Stable
Possibility of Hazardous Reactions: Hazardous polymerization will not occur.
Conditions to Avoid: Avoid heat, flames and other sources of ignition.
Incompatible Materials: Strong oxidizing agents.
Hazardous Decomposition Products: Carbon oxides, sulfur oxides, smoke fumes and unburned
hydrocarbons.