SDS

Page 3 of 5
5 mg/m3 TWA OSHA PEL
LVP Aliphatic Hydrocarbon
1200 mg/m3 TWA (manufacturer recommended)
The Following Controls are Recommended for Normal Consumer Use of this Product
Engineering Controls: Use in a well-ventilated area.
Personal Protection:
Eye Protection: Avoid eye contact. Safety glasses or goggles recommended.
Skin Protection: Avoid prolonged skin contact. Chemical resistant gloves recommended for operations
where skin contact is likely.
Respiratory Protection: None needed for normal use with adequate ventilation.
For Bulk Processing or Workplace Use the Following Controls are Recommended
Engineering Controls: Use adequate general and local exhaust ventilation to maintain exposure levels
below that occupational exposure limits.
Personal Protection:
Eye Protection: Safety goggles recommended where eye contact is possible.
Skin Protection: Wear chemical resistant gloves.
Respiratory Protection: None required if ventilation is adequate. If the occupational exposure limits are
exceeded, wear a NIOSH approved respirator. Respirator selection and use should be based on contaminant
type, form and concentration. Follow OSHA 1910.134, ANSI Z88.2 and good Industrial Hygiene practice.
Work/Hygiene Practices: Wash with soap and water after handling.
9 – Physical and Chemical Properties
Appearance:
Light amber liquid
Flammable Limits:
(Solvent Portion)
LEL: 0.6% UEL: 8.0%
Odor:
Mild petroleum odor
Vapor Pressure:
1 psi @38C (100F)
ASTM D323
Odor Threshold:
Not established
Vapor Density:
Greater than 1 (air=1)
pH:
Not Applicable
Relative Density:
0.8 – 0.82 @ 60F
Melting/Freezing Point
Not established
Solubilities:
Insoluble in water
Boiling Point/Range:
361 - 369F (183 -
187°C)
Partition Coefficient; n-
octanol/water:
Not established
Flash Point:
122F (49°C) Tag Open
Cup
Autoignition
Temperature:
Not established
Evaporation Rate:
Not established
Decomposition
Temperature:
Not established
Flammability (solid, gas)
Not Applicable
Viscosity:
2.79-2.96 cSt @
100F
VOC:
412 grams/liter (49.5%)
Pour Point:
-63C (-81.4F ) ASTM
D-97
10 – Stability and Reactivity
Stability: Stable
Hazardous Polymerization: Will not occur.
Conditions to Avoid: Avoid heat, sparks, flames and other sources of ignition.
Incompatibilities: Strong oxidizing agents.
Hazardous Decomposition Products: Carbon monoxide and carbon dioxide.
11 – Toxicological Information
Symptoms of Overexposure:
Inhalation: High concentrations may cause nasal and respiratory irritation and central nervous system effects
such as headache, dizziness and nausea. Intentional abuse may be harmful or fatal.