User Manual

Shenzhen Waytronic Electronics Co., Ltd. Microsound V22.15
- 4 -
Slide Switch
To the bottom
Switch off
To the middle
Small volume
Uppermost
Maximum volume
Playing
indicator light
Light off
Power off or no voice playing
Light on
Voice playing
Button A
Short press
Play the previous audio
Long press
Switch to A/B mode: Indicator light flashes once, means it is A
mode(loop sequence ), flashes twice means it is B mode(single
playback).
Button B
Short press
Play the next audio
Micro USB
interface
Connect DC5V power
adapter or computer
Supply power; download audio files.
★
Note:
1. When switch on, wait about 20S, then it can work normally. Within 4 meters, when people or animal walk by, it
will trigger the sensor to play voice.
2. Each time, after triggering to play voice, you need to wait 2S, then it can trigger again to play voice.
3. Each time, after triggering, go out of the induction range and enter the range again, then it can have a better
effect of the next trigger.
4. In B mode, you only need to short press key A or B to select audition of the triggering voice, need no other
operations.
5. Key function is only valid during the process of voice playing. If no voice play, it’s invalid to press key.
6. If plug in the power, please remember to remove the batteries to avoid unexpected accidents.
5. Audio download
It’s easy to replace audio files. Just use USB cable to connect to computer, here will appear a drive. You just need
to copy audio files into this drive.
★
Note:
1. The audio file size should be not more than internal FLASH capacity. Only support MP3 audio format.
2. After copying is complete, sometimes play a section voice. When finishing the voice play, 3 seconds later, it
can trigger and play again.
You can copy any voice, tones, music, into this product, as long as the format is MP3, within memory capacity.
Besides, you can make your own personalized voice.
6. Brief operation introduction
How to replace voice files:
1. Convert the voice into MP3 format.