Owner`s manual

28 of 46

PROPANE TANK OPERATION

REMOVING A PROPANE TANK FROM THE ASSEMBLY STAND

1. Turn off both tanks, by turning the valve knobs in a clockwise direction to close.

2. Remove the LP pigtails, by turning the nuts in a counter clockwise direction to loosen.

3. The protective dust cap must be installed on the valve outlet.

4. Loosen the wing nut on the tank lock bar and lift up the regulator bracket. Lift the locking bar to free it

from the top ring of the tanks and turn it 90° from the locked position.

5. Lift the cylinder straight up to remove.

INSTALLING A PROPANE TANK INTO THE DUAL TANK STAND

1. Lower tank into the stand base, making sure the tank is sitting firmly in the base.

2. Lift and turn lock bar into slots of the top ring of the tank, making sure it is fully engaged in the ring of

both tanks.

3. Confirm the tab of the regulator bracket is locked into the slot in the top of the lock bar. Tighten the wing

nut until the lock bar is securely holding the tanks in place.

4. Lift tanks by handle and wiggle them to confirm they are fastened down securely, retightening wing nut if

necessary.

5. Remove the protective dust cap and attach the LP Pigtails. Turn knob clockwise to tighten.

6. Slowly open gas valves and check for gas leaks.

Protective boot

Locking bar

Wingnut

LP pigtail

Valve knob

Regulator