Instructions / Assembly

ManualsBrandsWAYNE Pumps ManualsBattery Back-up Sump SystemsESP25 Upgraded 12-Volt Battery Back-Up System

SPECIFICATIONS

POWER SUPPLY REQUIREMENTS 12 V, DC

MOTOR Dielectric Oil Filled

POWER 12 V

CIRCUIT REQUIREMENT 12 V DC Battery

LIQUID TEMPERATURE RANGE 40° F- 120° F

CONSTRUCTION

MOTOR HOUSING Coated Steel

MOTOR SHAFT Stainless Steel

IMPELLER Thermoplastic

VOLUTE Thermoplastic

PUMP DISCHARGE 1-1/2 in. NPT

12 Volt Backup Sump Pump

www.waynepumps.com

PERFORMANCE

Model Volt

Discharge Head

0 ft. 5 ft. 10 ft. 15 ft.

ESP25-N 12 V Gal/hr 2900 2340 1680 600

Intended for Indoor Use Only

Please read and save these instructions. Read carefully before attempting to assemble, install,

operate or maintain the product described. Protect yourself and others by observing all safety

information. Failure to comply with instructions could result in personal injury and/or property

damage! Retain instructions for future reference.

Operating Instructions and Parts Manual ESP25-N

Summary of content (12 pages)

PAGE 1
2 Volt Backup Sump Pump Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions for future reference.
PAGE 2
Operating Instructions and Parts Manual DESCRIPTION GENERAL SAFETY INFORMATION The ESP25-N is a battery operated backup sump pump. It does not replace a regular pump. It is designed to provide protection in the event household electrical power fails. This system is intended for indoor use only. This pump is intended for use with one 12 V battery only. CALIFORNIA PROPOSITION 65 UNPACKING Inspect this unit before it is used. Occasionally, products are damaged during shipment.
PAGE 3
Operating Instructions and Parts Manual electrician. électricien qualifié. All wiring must be performed by a qualified L'ensemble du câblage doit être effectué par un Do not expose battery to sparks or flame as an explosion or fire could result. Ne pas exposer la batterie à des étincelles ou des flammes. Une explosion ou un incendie pourrait en résulter. Battery acid is corrosive. Avoid spilling on skin or clothing. Eye protection must be worn when handling the battery.
PAGE 4
Operating Instructions and Parts Manual vicinity of the battery. Never smoke or allow a spark or flame in the Ne jamais fumer ou laisser une étincelle ou une flamme près de la batterie. Avoid dropping metal tools on the battery posts because they may spark or short-circuit the system or battery, causing an explosion. Éviter de faire tomber des objets en métal sur les bornes de la batterie : cela pourrait créer des étincelles ou des courts-circuits du système ou de la batterie, provoquant une explosion.
PAGE 5
Operating Instructions and Parts Manual INSTALLATION CONT'D ESP25-N Control Box Installation Method 2 1. Place battery in box, attach red cable to positive battery post and black cable to negative battery post. If a separate, dedicated discharge is not possible as in Method 1, the backup pump can be tied into the AC operated pump's discharge pipe by installing a "Y" connector. Two check valves will be required.
PAGE 6
Operating Instructions and Parts Manual Risk of electrical shock! Use a gfci receptacle to reduce the risk of fatal electric shock. Cutting the cord will void the warranty and make the pump inoperable. FLOOR JOIST SLOPE PIPE DOWN 1. After installation, the backup pump will start when the water level rises above the backup float switch.
PAGE 7
Operating Instructions and Parts Manual MAINTENANCE ESP25-N NOTES Always disconnect the electrical supply before attempting to install, service or relocate or perform any maintenance. If the power source is out of sight, lock and tag in the open (off) position to prevent unexpected power application. Failure to do so could result in fatal electric shock. Only qualified electricians should repair this unit. Improper repair could result in fatal electric shock.
PAGE 8
Operating Instructions and Parts Manual TROUBLESHOOTING CHART Symptoms Possible Cause(s) Suggested Remedies Pump will not start or run 1. Connections not secure 1. Check all connections 2. Low or defective battery 2. Check battery and replace if low or defective 3. Float switch stuck 3. Make sure nothing is interfering with operation of switch 4. Defective or blown fust 4. Check internal fuse located inside the control box. Pull the transformer from the wall outlet and remove.
PAGE 9
Operating Instructions and Parts Manual ESP25-N For Replacement Parts or Customer Support, Call 1-800-237-0987 Please provide following information: - Model number - Serial number (if any) - Part description and number as shown in parts list Address any correspondence to: Wayne Water Systems 101 Production Drive Harrison, OH 45030 U.S.A.
PAGE 10
Operating Instructions and Parts Manual NOTES 10
PAGE 11
Operating Instructions and Parts Manual ESP25-N NOTES 11
PAGE 12
www.waynepumps.