Owner`s manual

1
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
Tools Needed:
Flat Tip
Screwdriver
1
Retro-Fit Installation
Spring Tension Removal
COUNTERBALANCE SPRING TENSION
MUST BE RELIEVED BEFORE REMOVING
ANY HARDWARE. A POWERFUL SPRING
RELEASING ITS ENERGY SUDDENLY CAN
CAUSE SEVERE, EVEN FATAL INJURY.
Place door in the fully closed position and
remove Drum Wraps from Cable Drums
(if installed).
Using a 7/16" Wrench, loosen Lock Nut on
the back of the End Bracket. Using a Power
Drill (high torque/gear reduced to 1300 RPM
preferred), with a 7/16" Socket Driver,
unwind the right hand Winding Bolt counter
clockwise until the Counter Cover shows “0”
(zero). If the door has two springs, repeat
this process for the left hand side.
NOTE: A door with only one spring will
not have a counter assembly on the left
hand side.
NOTE: Spring(s) is/are fully unwound when
Counterbalance Cables have no tension.
CAUTION: DO NOT USE AN IMPACT GUN
TO UNWIND THE SPRINGS!
NOTE: It is recommended that Cable Drums
and End Bracket assemblies get updated to
current designs for optimal performance.
Current End Brackets are made of metal
instead of plastic, and Counter Cover and
Worm Gears are made of grey plastic,
instead of black and white plastic. If new
parts are required, contact Wayne-Dalton
Customer Service.
2
Right Hand Counter Removal
IMPORTANT! Right and left hand is always
determined from inside the garage looking
out.
Remove the Counter Cover. Slide a Flat Tip
Screwdriver between the End Bracket and
the Counter Gear.
Gently pull the Counter Gear away from the
End Bracket. If the door has two springs,
repeat this process for the opposite side.
7/16”
Wrench
Lock Nut
Power
Drill
Counter
Balance
Cable
Drum
Wrap
End Brackets
(Metal)
Counter
Cover
Worm
Gear
Counter
Gear
Flat Tip
Screwdriver
End Brackets
(Metal)
Counter
Cover
WARNING
Winding
Bolt
Winding
Bolt
Tools Needed:
7/16" Wrench
Power Drill
7/16"
Socket Driver
Step Ladder
INSTALLATION NOTICE: If installing this idrive
®
Opener on a door currently installed with a Torquemaster
®
counterbalance system, start installation
on Step: 1 below. If Installing this idrive
®
Opener as part of a new door installation, complete the door installation first (using instructions supplied
with the door), then proceed to Step: 25 on page 13, of this manual, for the remaining Opener installation procedures.
Cable
Drum
7/16”
Socket Driver