Owner`s manual

ManualsBrandsWayne-Dalton ManualsGarage Door OpenerOptimal

�

Customizing the Settings

Custom pet position:

Normal install routine sets the pet position to approximately 8

inches above the ground. The pet opening height may be changed

to open anywhere between 8” and 30” above the ground. To

change the automatic pet opening height refer to the following

procedure:

a. After completion of the normal install routine, with the door in

the closed position, place the Disconnect Handle in the Manual

Operated Position.

Manually position the door to the desired pet opening height

(between 8” and 30” above ground) and return Disconnect

Handle to the Motor Operated Position.

b. Move the Slide Switch from the NORMAL (Unlock) position to

the DOOR LOCK (Lock) position and then back to the NORMAL

(Unlock) position. The Opener will beep once. The Pet Button is

now programmed to automatically open the door to this custom

height.

NOTE: The Opener will NOT accept programmed pet lock position

if door is below 8” or higher than 30”.

NOTE: Activation of the normal install routine will reset the pet

position to the default 8” target height. For use of the Pet Button

see Operation section.

Multi-Door Programming:

Momentarily pressing the button programmed in the Transmitter

Programming Step activates the door. Other buttons can also be

programmed to activate different doors, for multi-door installations.

Each button or a combination of two buttons pressed

simultaneously can be programmed to activate a different door.

Only one button at a time can be programmed to activate a

specific Opener. The Transmitter LED will light while any

Transmitter button remains pressed.

Custom Upper Limits

Disconnect door and manually move it to the desired upper limit.

Reconnect door.

Press and hold the Profile Button for 5 seconds. The Opener will

beep twice, indicating the activation of the install routine. The door

will now move to the closed position. Then, the door will open to

the new upper limit.

Next, the door will go down to the closed position. Once this is

complete, the door limits are set and the installation is complete.

For more profile options go to page 21 and 22.

NOTE: Before performing custom upper limit, first profile must be

done from closed position.

Pet Button

Profile Button

Up/Down Button

NORMAL

DOOR LOCK

Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need.

You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com