Owner`s manual

�
Programming HomeLink
®
System to the Torquemaster
®
idrive
®
(Alternate)
30
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
Programming/Training HomeLink
®
Unit
GARAGE DOOR MAY OPERATE DURING PROGRAMMING. TO AVOID
POSSIBLE SEVERE OR FATAL INJURY, PLACE THE EMERGENCY
DISCONNECT HANDLE IN THE MANUAL OPERATED POSITION.
1. Pull the Manual Disconnect to put the opener in the disengaged
position.
2. Press and hold the two outside buttons on the HomeLink
®
unit until the HomeLink
®
light begins to flash rapidly (approx. 20
seconds), then release both buttons. (Do not perform this step to
train additional hand-held transmitters.) Note: This operation
erases all previously learned transmitters and that you need to
re-teach any other transmitters to your HomeLink
®
unit by
repeating steps 3 - 6 below.
3. Hold the end of the Wayne
®
Dalton hand-held transmitter
approximately 1 to 3 inches away from the HomeLink
®
surface –
keeping the HomeLink
®
indicator light in view.
4. Press and hold the Wayne
®
Dalton hand-held transmitter’s large
center button. Ensure the transmitter has been taught to the
opener.
5. The transmitter’s red Light Emitting Diode (LED) will turn on and
after 10 seconds flash on and off, immediately press desired
Homelink
®
button, DO NOT release the Wayne
®
Dalton transmitter
button.
6. The HomeLink
®
indicator light will be blinking during the training
operation. When the HomeLink
®
indicator light flashes rapidly or
turns off (approx. 5 to 60 seconds), both buttons may be released.
The HomeLink
®
indicator light flashing rapidly or turning off
indicates successful programming of the new frequency signal.
Teaching HomeLink
®
to the idrive
®
Opener
7. Press and release the red program button on the idrive
®
opener.
The idrive
®
unit will beep, indicating that it is ready to learn.
Note: The idrive
®
will remain in the learn mode for 30 seconds.
8. Press the HomeLink
®
button used in Step 5 above for 1 to 3
seconds. The idrive
®
will beep indicating a successful learn.
9. Return the Manual Disconnect to the engaged position.
10. Press the HomeLink
®
button once more to operate the door.
Note: The first transmitter command after programming will only move
the door through a six inch up/down cycle. Normal door operations will
occur on the second use of the transmitter.
NOTE: This Step can only be done on automobiles equipped with the
HomeLink
®
System.
NOTE: Programming HomeLink
®
requires a Wayne-Dalton Transmitter
that is programmed to the Torquemaster
®
idrive
®
per Step 42.
IMPORTANT: Use the programming instructions provided with your
vehicle first. Follow these instructions if the HomeLink
®
unit does not
learn the Transmitter, when using the vehicle’s instructions.
Note: Vehicle may need to be in accessory position when
programming. Check car owner’s manual.
Note: HomeLink
®
is a registered trademark of Johnson Controls.
WARNING