Owner`s manual

21
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
Tools Needed:
None
TO AVOID INJURY, NO ONE SHOULD
CROSS THE PATH OF A MOVING DOOR!
The install routine automatically sets the door
open and close limits and calibrates
obstruction sensing. During the install
routine, the door will move up and down
twice.
NOTE: If an object such as a ceiling beam
obstructs the door from opening completely,
skip this step. Set a Custom Upper Limit, see
Step 37.
NOTE: The door must be in its fully closed
position and the Disconnect Handle must
be in the Motor Operated Position (upper
position) to initiate the install routine.
NOTE: Install routine will not run if Safety
Sensors are not aligned (only if required
installation).
Press and hold the Profile Button for
five (5) seconds. The Opener will beep
twice, release the Profile Button, indicating
the activation of the install routine. The door
will now move to the fully open position and
stop, beep twice and then the door will close
completely.
Next, the door will go through one more up/
down cycle. Once this is complete, the door
limits are set and the installation is
complete.
NOTE: Upon successful completion of Step
36, proceed to Step 38.
Install Routine
(Standard Upper Limit)
Programming Light Fixture
Program Button
Light Button
Profile
Button
Tools Needed:
None
LED
WARNING
35
36
Press the red Program Button on the Light
Fixture. The LED on the Light Fixture will
turn on and remain on for 30 seconds
or until a Wall Station is learned. The
incandescent lamp will also turn on
when Program Button is pushed.
Press the Light Button on the Wall Station.
This must be done within 30 seconds of
pressing the Program Button on the Light
Fixture. The Light Fixture Lamp and LED will
blink three times to indicate successful
programming. The Light Fixture can now be
turned on and off from this Wall Station.
NOTE: In order to program the Light to
the Opener, the installer must have the Wall
Station already programmed to the Opener.