Owner`s manual

17
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
Receiving
Unit
LED
Washer
Nut
1/4”-20 x 1/2”
Carriage Bolt
5/16 x 1-1/2”
Lag Screw
Door Jam
U-Bracket
Wall Mounting
Bracket
30
NOTE (Per UL): Safety Sensors are
required if Opener is installed on a non-
pinch resistant door. If they are not required,
skip this step and proceed with Step 33.
a. Select and mark with a pencil, a
mounting location no more than
5 inches above the floor to center line
of Wall Mounting Bracket. The Safety
Sensors should be mounted as close to
the door track or inside edge of the door
as possible to offer maximum entrapment
protection. It is very important that both
Wall Mounting Brackets be mounted at
the same height for proper alignment.
Note: Use Steps a-c for installing sensors
on both sides of the garage door.
IMPORTANT! Both Wall Brackets
must be mounted at the same height
for proper alignment.
b. Drill pilot holes, using a 3/16” drill bit.
Using two 5/16 x 1-1/2” Lag Screws,
permanently mount the Wall Mounting
Brackets to both door jambs. In some
installations it may be necessary to
attach a wooden spacer to the wall to
achieve the required alignment.
Attach the “U” Brackets to the Wall
Mounting Brackets with 1/4”-20 x 1/2”
Carriage Bolts, Washers and Nuts.
Insert the Bolts from the inside of the
“U” Bracket and hand-tighten.
c. Attach the Sending and Receiving Safety
Sensors to the “U” Brackets by inserting
all three tabs into the respective holes.
IMPORTANT! Identify which side of the
garage door is exposed to the most sunlight.
Mount the Sending Unit (Unit without LED) on
the side which is exposed to the most sun.
Sunlight may affect the Safety Sensors, and
this orientation will help reduce the effect.
Tools Needed:
Tape Measure
Power Drill
3/16" Bit
7/16” Socket Driver
7/16” Wrench
Pencil
Safety Sensors Installation
8000 Series Doors
(Not Required On 9000 Series Doors)
a
b
c
Wall Mounting
Bracket
5”