User Manual

3
8000/8100/8200 DOORS, (SEE FIG. 4): Align the outside handle
assembly with the handle pointing towards the floor and insert the
assembly through the previously drilled 3/4” diameter holes in the
section. Secure the outside lock handle to the section with (2) #10
phillips head screws.
5120/5140/6100/8300/8500/9700/9800/9100/9400/9600 & WOOD
DOORS, (SEE FIG. 5A & FIG. 5B): Align the outside handle assembly
with the handle pointing towards the floor and insert the assembly
through the previously drilled 3/4” diameter holes in the section. With
the outside lock placed in the section, place the center lock stile over
the shank of the outside lock handle, secure the center lock stile with
foam tape (8300/8500/8700/9800/9700 & WOOD DOORS will use the
lock backup plate with no foam tape). Secure the outside lock handle
to the section by placing the (2) #10 phillips head machine screws
through the lock stile into the lock section.
Hold the disk with the large notch of the release disk pointing up. Feed
the cables thru the tabs as shown (SEE FIG. 6).
First place the 3/8” x 1” washer over the square steel shank. Hold the
handle which is pointing towards the floor with one hand and place
the disk assembly over the square steel shank of the outside handle.
Push the retainer nut onto the shank until the free play in the assem-
bly is taken up. Operate the lock to make sure it functions properly. If
the lock operates too hard, loosen the retainer nut slightly. Place the
inside handle over the extruded holes in the release disk. Secure the
handle with (2) 1/4” - 20 x 1-3/4” self tapping screws. Insert the rim
cylinder through the trim ring and into the section with the teeth side
of the key pointing away from the outside handle, (SEE FIG. 7).
Place the lock plate over the 1-1/4” diameter center stile hole and
fasten with (2) #12 pan head screws into the rim cylinder. In addition,
align the night latch slide with the notch in the top of the release disk.
Fasten the night latch to the center stile with (4) #8 x 1/2” pan head
screws, (SEE FIG. 8).
NOTE: Follow the Main Installation Instruction Manual to install the
door sections and vertical track before you install the remainder of
the lock parts. After the sections and track are installed, continue with
STEP 4.
STEP 2: Outside Lock Handle Assembly
STEP 3: Inside Handle / Lock Assembly
Outside
handle
3/4” dia.
holes
#10 Phillips
head screws
Shank
3/4” Dia.
holes
Outside
handle
#10
Phillips
head
screws
Handle
shank
Foam tape
Universal
lock stile
FIG. 4
FIG. 5
Foam tape
Shank
(outside handle)
Release
disk
Retainer
nut
3/8” x 1”
Washer
FIG. 5B
FIG. 7
Release
disk
Cable
tabs
Large notch
“up”
Feed cable
through
holes in
cable tabs
FIG. 6
3/4” Dia.
holes
Outside
handle
#10
Phillips
head
screws
Handle
shank
Lock
backup
plate