Owner`s manual

26
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
Tools Needed:
18
With tracks installed you can adjust the
top brackets. Vertically align the top
section with the lower sections. Once
aligned, position top roller in adjustable
slide against horizontal track to maintain
position and tighten nut. Repeat for
other side.
Adjusting Top Brackets
7/16” Wrench
HORIZONTAL
TRACK
TOP BRACKET
SLIDE
CORRECT
INCORRECT
TOP ROLLER
TOP
SECTION
TOP
SECTION
TOP
SECTION
Tape Measure
Pencil
Power Drill
9/32” Drill Bit
1/2” Drill Bit
1/4” Wrench
19
Lift Handle
NOTE: Doors with Keyed lock do not require this lift
handle.
Raise the door to a comfortable working height and
secure with vice clamp to the track. Locate the inside
center stile or the desired lift handle location on the lock
(2nd) section of the door.
Measure up 4 inches from the bottom of the second
section. Using this measurement as a guide, position
lift handle bottom hole and make a mark at the top hole
in lift handle. This should give you a Min. of 20 in. and
a Max. of 30 in. between the lower lift handle/gripping
point and the middle of the upper lift handle/gripping
point. If needed reposition upper lift handle to stay within
Min. and Max. dimension.
Drill two 9/32 in. (8mm) dia. holes through section.
Enlarge the holes from outside the door to 1/2” (13mm)
dia.
NOTE: Do not drill through or enlarge holes on the inside
of the door.
Assemble the outside and inside lift handle/gripping
points to the section using (2) 1/4” x 2 1/2” carriage
bolts, (2) 1/4”- 20 hex nuts and (2) spacers.
LIFT HANDLE OUTSIDE
LIFT HANDLE INSIDE
LOCK
SECTION
LOCK
SECTION
LOCK
SECTION
LOCK
SECTION
BOTTOM
SECTION
BOTTOM
SECTION
BOTTOM
SECTION
BOTTOM SECTION
LIFT
HANDLE
LIFT
HANDLE
LIFT
HANDLE
LIFT
HANDLE
(2) SPACERS
(2) 1/4”- 20
HEX NUTS
(2) 1/4” X 2-1/2”
CARRIAGE BOLTS