Owner`s manual

25
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
INSTALLATION
17
9/16” Socket
Ratchet Wrench
9/16” Wrench
Level
Hammer
Attaching Quick Install Flagangle
to Horizontal Track
NOTE: If quick install flagangle was
installed in Step 16, skip this step and
continue with Step 18. If not, complete
this step.
Align key slot of the horizontal track
with the quick install tab of the
flagangle. Push curved portion of
horizontal track down to lock in place.
DO NOT RAISE DOOR UNTIL
HORIZONTAL TRACKS ARE
SE CURED AT REAR, AS OUTLINED
IN STEP 20, OR DOOR COULD
FALL FROM OVERHEAD
POSI TION CAUSING SEVERE OR
FATAL INJURY.
Level the horizontal track assembly and
bolt the horizontal angle to the slot in
the flagangle using (1) 3/8”- 16 x 3/4”
truss head bolt and (1) 3/8”- 16 hex
nut. Repeat for other side. Remove the
nail that was temporarily holding the top
section in place, installed in Step 15.
IMPORTANT: FAILURE TO REMOVE NAIL
BEFORE ATTEMPTING TO RAISE DOOR
COULD CAUSE PERMANENT DAMAGE
TO TOP SECTION.
KEY SLOT
QUICK
INSTALL
TAB
HORIZONTAL
TRACK
VERTICAL
TRACK
FLAGANGLE
WARNING
KEY SLOT
QUICK
INSTALL
TAB
HORIZONTAL
TRACK
VERTICAL
TRACK
FLAGANGLE
3/8- 16 X 3/4”
TRUSS HEAD BOLT
3/8”- 16
HEX NUT
FLAGANGLE
HORIZONTAL ANGLE