Owner`s manual

24
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
NOTE: If you have quick install
flagangle, skip this step and complete
Step 17.
Align the bottom of the horizontal track
with the vertical track. Hand tighten the
horizontal track to the flagangle with
(2) 1/4”- 20 x 9/16” large head ribbed
track bolts and (2) 1/4”- 20 flange hex
nuts.
DO NOT RAISE DOOR UNTIL
HORIZONTAL TRACKS ARE
SE CURED AT REAR, AS OUTLINED
IN STEP 20, OR DOOR COULD
FALL FROM OVERHEAD POSITION
CAUSING SEVERE OR FATAL
INJURY.
Level the horizontal track assembly and
bolt the horizontal angle to the slot in
the flagangle using (1) 3/8”- 16 x 3/4”
truss head bolt and (1) 3/8”- 16 hex
nut. Repeat for other side. Remove the
nail that was temporarily holding the top
section in place, installed in Step 15.
IMPORTANT: FAILURE TO REMOVE NAIL
BEFORE ATTEMPTING TO RAISE DOOR
COULD CAUSE PERMANENT DAMAGE
TO TOP SECTION.
NOTE: After completing this step,
continue with Step 18.
3/8”- 16 X 3/4”
TRUSS HEAD BOLT
3/8”- 16
HEX NUT
FLAGANGLE
HORIZONTAL ANGLE
WARNING
16
9/16” Socket
7/16” Socket
Ratchet Wrench
9/16” Wrench
Level
Hammer
Flat Tip
Screwdriver
Attaching Adjustable Flagangle
to Horizontal Track
1/4”- 20 FLANGE
HEX NUTS
FLAGANGLE
1/4”- 20 X 9/16”
LARGE HEAD
RIBBED TRACK
BOLTS