Installation & Assembly

ManualsBrandsWayfair Basics ManualsCabinet & Pantry OrganizationSliding Pot Organizer Pull Out Drawer

INSTALLATION INSTRUCTIONS – In Cabinet

Cabinet must be at least 20”W x 20”D.

Place CABINET MOUNTING TEMPLATE (G) inside your

cabinet. Using a pencil, mark the location where you plan

to install the CABINET SCREWS (F).

• To ease installation you can pre-drill small holes at the

marked locations.

Identify LEFT (B) and RIGHT (C) SLIDES.

• Note that the BACK end of each SLIDE (B & C) has a black tip

and the FRONT end does NOT.

Place LEFT (B) RIGHT (C) SLIDES in their proper orientation and

desired position inside the cabinet.

B (1) C (1) F (4)

G (1)

STEP 1

STEP 2

Extend the SLIDES (B) & (C) slightly and align the center of the oval slots to your marking in the cabinet.

Use the self-tapping CABINET SCREWS (F) to fasten the LEFT (B) and RIGHT (C) SLIDES in your cabinet.

FRONT

BACK

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS – In Cabinet STEP 1 Cabinet must be at least 20”W x 20”D. G (1) Place CABINET MOUNTING TEMPLATE (G) inside your cabinet. Using a pencil, mark the location where you plan to install the CABINET SCREWS (F). • To ease installation you can pre-drill small holes at the marked locations. STEP 2 Identify LEFT (B) and RIGHT (C) SLIDES. • Note that the BACK end of each SLIDE (B & C) has a black tip and the FRONT end does NOT.
PAGE 2
INSTALLATION INSTRUCTIONS – In Cabinet STEP 3 Align POT ORGANIZER (A) at the marked location and push it into the Clips of the LEFT (B) RIGHT (C) SLIDES A (1) Installation Suggestion: With the POT ORGANIZER (A) resting on top of the Clips, brace the top of the POT ORGANIZER (A) with one hand and, with a rubber mallet, lightly tap each bottom corner of the POT ORGANIZER (A) to secure the POT ORGANIZER (A) into the Clips.
PAGE 3
INSTALLATION INSTRUCTIONS – On Wire Rack STEP 1 The wire shelf needs to be a minimum of 20” in depth. Identify the LEFT (B) & RIGHT (C) SLIDES. • Note that the BACK end of each SLIDE (B & C) has a black tip and the FRONT end does NOT. B (1) C (1) Place SLIDES (B & C) on desired wire shelf. Make sure the FRONT of the SLIDES (B & C) are lined up with the FRONT of the shelf. Line up the slides along the wires in the wire shelf to ensure they are straight.
PAGE 4
INSTALLATION INSTRUCTIONS – On Wire Rack STEP 3 With a Phillips screwdriver, secure the SLIDES (B & C) to the wire shelf by putting PLATE SCREWS (E) through the slots and fasten to the RACK PLATES (D). Note: RACK PLATES (D) need to be installed from the underside of the shelf. D (4) E (4) STEP 4 Attach the POT ORGANIZER (A) to the Clips in the LEFT (B) and RIGHT (C) SLIDES until it clicks into the Clip.