Manualshelf

Installation Manual

ManualsBrandsWayfair Basics™ ManualsCurtain Hardware & AccessoriesWayfair Basics End Cap Single Curtain Rod & Hardware Set
123
1
2
AB
3
SET SCREW
7
BA C
5
6
SET SCREW
4
A B
C
A B
BA C
BE SURE TO READ ALL INSTRUCTIONS BEFORE STARTING INSTALLATION
Care Instructions: Clean with a soft cloth. Do not use abrasive cleaning agents, solvents,
or polishes as they may damage the finish.
Estimated Assembly Time: Approximately 30 minutes
Tools Needed (not included): Drill with ³/
16 in drill bit, Phillips screwdriver, Level (recommended)
Bracket Installation (diagram 1):
1. Use bracket and level as guides to determine desired
position. Mark location on wall for mounting screws.
2. Remove bracket from wall. Where marked, drill pilot
holes with ³/
16 in. drill bit and insert wall anchors. (Wall
anchors may not be necessary for all applications.)
3. Attach bracket to wall using mounting screws
provided.
4. Repeat steps 1 to 3 for additional bracket.
Drapery and Rod Installation For Windows 72-95 inches:
Use 2 telescopic rod sections (A/B). Rod (C) will not
be used.
1. Extend telescopic rod slightly (diagram 2).
2. Place drapery panels onto drapery rod and attach
finials. Extend rod to desired length and hang rod
on brackets (diagram 3).
3. Tighten set screws to lock rod in place.
Drapery and Rod Installation For Windows
95-144 inches:
Use all 3 telescopic rod sections (A/B/C).
1. Extend telescopic rod slightly (diagram 4).
2. Slide additional rod (C) over smaller diameter rod (B)
(diagram 5). NOTE: At this point, you should have
a complete telescopic rod; two large diameter rods
connected with one smaller diameter rod section
in the middle.
3. Place drapery panels onto drapery rod and attach
other finial. Extend rod to desired length and hang
rod on brackets. Tighten set screws to lock rod in
place (diagram 6).
Center Support Bracket Installation (diagram 7):
(included with 36-72 and 72-144 inch sets)
1. Locate center of rod.
2. Use center support bracket as guide to determine
desired position. Mark location on wall for mounting
screws.
3. Remove bracket from wall. Where marked, drill pilot
holes with ³/
16 in drill bit and insert wall anchors. (Wall
anchors may not be necessary for all applications.)
4. Attach bracket to wall using mounting screws
provided.
1
Questions: Call customer service at 1-877-888-8225

Summary of content (3 pages)