User Manual

OPERATION

The unit is normally self powered by the pack under test, the only

control being an operate button.

ESR is measured at high current to simulate real operating levels.

When connected to the pack, the display will read “Hold to set

mAH” for approx. 3 seconds and then default to reading Pack

voltage.

If you wish to just read Pack and Cell voltage, Charge State and ESR

you can do so by toggling the operate button for Pack Voltage and

ESR without connecting the search lead. For Cell Voltage and ESR

connect the search lead to the appropriate two sockets in the balance

connector and the meter will read Cell Voltage and charge state.

Push the operate button to read Cell ESR. The operate button will

now toggle the display between Voltage with % charge and ESR.

In order to read the maximum safe current and Real “C” for the Lipo

you need to input the capacity of the pack in mAh. To do this refer

to the attached “OPERATING SEQUENCE”

Note: You can only start to input mAh values when the meter is

reading Voltage. If it is reading ESR pushing the button will toggle

the display to Voltage. Then Press + Hold

SPECIFICATION

Mode Max Range ESR Res. Accuracy Voltage Res. Accuracy

PACK 0-250mΩ 0.3mΩ <3% 40mV <0.5%

CELL 0-35mΩ 0.04mΩ <2% 10mV <0.3%