User Manual

12
PB - Bleep
Cell ESR =
XX.XXm.Ω
(“C” = XX max I =
XXXA)*
Reading Cell IR,
Real “C” value and
max safe current for
Cell 2
Repeat last two steps
for each cell
* Setting the pack capacity in order to calculate Real “C” and
maximum safe current.
PBH – 2 secs –
Bleep – Release.
(Meter MUST be
reading Voltage)
Set mAh hundreds
000mAh
Now ready to take
100s 0f mAh
PB to step 100s of
mAH -Bleep at each
step
Set mAH hundreds
X00mAH
Each PB adds
100mAh up to
900mAh max
PBH – 2 secs –
Bleep - Release
Set mAH thousands
X00mAH
Now ready to take
1000s of mAh
PB to step 1000s 0f
mAh – Bleep at each
step
Set mAH thousands
XX00mAH
Each PB will add
1000mAh
Up to 10,000mAH
max
PBH – 2secs – Bleep
- Release
Capacity set to :
XX00 mAh
Set capacity
displayed for 3 secs
Display then reverts
to voltage
NOTES: (1) Loading in mAh quickly becomes intuitive. If you go past a value,
carry on as the system recycles to zero after full range. You cannot get in a mess
as there is only one button! You can always disconnect the power lead – the
capacity memory will reset to zero after each disconnection.
(2) Max I is the maximum continuous recommended current which will result
in a decent life span for the Lipo. Surges of up to 40% higher are generally
acceptable for short periods ie 10 – 20 seconds. It is ESSENTIAL to take
readings at 22⁰C - 25⁰C (72⁰F - 77⁰) for correct IR, Imax and real “C” readings.