User Guide

11 12
VI How to use
1. Power on the Subnado, confirm the power level ( refer to figure 1) and the
main unit’s self-checking tone.
2. Quickly press the trigger twice to switch to high or low gear. Quickly press
the trigger triple times to switch on/off the super gear mode. The number of
beeps indicates the gear that the user has entered. "One beep" prompts to
enter low gear; "Two beeps" prompt to enter high gear; "Three beeps" prompt
to enter super gear. (Note: The Super gear only maintains for 1 minute. To
re-enter Super gear, you need to press the trigger 3 times quickly. )
3. The Subnado supports two modes. To turn on/off the cruise mode,
simultaneously hold down the trigger and power on the machine.
c. Put the finger safe-guard into the groove, press each end of the finger
safe-guard into place, and make sure the end of the finger safe-guard is
engaged with the notch in the groove (as shown in the figure)
d. Put the pin in place correctly and assemble the propeller.
end
e. Install the O-ring in place,place the rear cover center aligned with the shaft,
and tighten the rear cover counterclockwise.
Cruise mode
How it works
8 LED lights flash once and shows the battery power level
Under cruise mode, the propeller rotates when pressing the
trigger. After 15 seconds, when there is a transient speed
change, it enters auto cruise. Users can release the trigger,
and the propeller will continue rotating. Press the trigger again,
and the propeller will stop rotating and exit the auto cruise.
For assembling and using other accessories, please refer to the relevant
documents on the official website. www.waydootech.com
Mode
Power-on
indication
Regular Working mode
Power-on
indication
Mode
How it works
8 LED lights flash twice and shows the battery power level
Under regular working mode, the propeller rotates when
pressing the trigger and stops after releasing.