Instructions / Assembly

version 1220

THIS SIDE UP

WARNING: CHOCKING HAZARD

Small parts NOT for children under 3 years

32 Pins

4 Vertical zBoards

adhesive strips on 2 edges

of each zBoard

2 Backer Boards

adhesives strips on 2 edges

2 Horizontal zBoards -

top and bottom

holes on one side only

Included

2-SHELF STORAGE

• Assemble your unit on a ﬂat even surface

• Make sure zBoard surfaces are clean and dry

• Do not place unit on its side or back as it will compromise it’s structural intergrity

• Indoor use only. Not in bathroom

1 2

4 5

Place alignment pins in

vertical zBoards and backboard.

Start with the bottom horizontal

zBoard. Align the vertical zBoards

and backboard to holes in the

horizontal zBoard. Align middle

zBoard.

When moving the unit, ﬁrst empty

contents. Lift the cube from the bottom

zBoard to keep adhesives intact.

Align the vertical zBoards and

backboard to the holes in the middle

zBoard. Align horiozontal zBoard and

press ﬁrmly to secure unit together.

Carefully remove the 3M

protective layer from adhesive.

Enjoy building possibilities!

1 Middle zBoard

holes on top and bottom

PAGE 1
2-SHELF STORAGE • Do not place unit on its side or back as it will compromise it’s structural intergrity • Make sure zBoard surfaces are clean and dry • Indoor use only. Not in bathroom THIS SIDE UP • Assemble your unit on a ﬂat even surface Included 1 Carefully remove the 3M protective layer from adhesive. 2 Place alignment pins in vertical zBoards and backboard. 3 Start with the bottom horizontal zBoard. Align the vertical zBoards and backboard to holes in the horizontal zBoard.