Installation Guide
Help and Comments www.waybasics.com/contact
version 0418
CAUTION placing unit on its side or back
will compromise structural integrity. Use
right side up.
Important
THIS SIDE UP
5
2
1
3
6
4
Carefully remove the protective
layer leaving the 3M adhesive
on zBoard (adhesive shown
in yellow). Place alignment pins
in vertical zBoards.
Align Vertical zBoard to backboard.
Align Middle zBoard.
Repeat steps 1-4 for next tier.
Align Horizontal zBoard on top
and press firmly to secure unit
together.
Fit backboard into Horizontal
zBoard groove.
UNDER DESK SHELF WITH DOOR
• Assemble your unit on a flat even surface
• Make sure zBoard surfaces are clean and dry
16 Pins
4 Vertical zBoards
adhesive on 2 sides
2 Horizontal zBoards
(top and bottom)
1 Middle zBoard with
magnetic door stopper
2 Back zBoards1 zBoard Door
WARNING: CHOKING HAZARD
Small parts NOT for children under 3 years
• When moving your Way Basics unit, lift from the bottom
• Indoor use only. Not in bathroom.
Included
(Press)
Orient door properly as shown and
align bottom pin. Press on spring
loaded top pin and insert.
Enjoy building possibilities!