Instructions / Assembly

Important
THIS SIDE UP
7 8
Align top horizontal zBoard
(holes on one side) to unit as
shown. Press down firmly.
Enjoy building possibilities!
Align middle horizontal zBoard
(holes on both sides) to unit
as shown. Press down firmly.
Align large backboard to unit
as shown and press down firmly.
Align vertical side zBoard
to unit as shown. Press down
firmly.
21 3 4
6
Carefully remove the protective
layer leaving the 3M adhesive
on zBoard (adhesive shown
in yellow).
First align the middle vertical
zBoard and press down firmly.
Next align small bottom zBoards
to horizontal and vertical zBoard
as shown. Press down firmly.
Align vertical side zBoard to unit
as shown. Press down firmly.
5
Place alignment pins
in vertical zBoards and
vertical middle zBoard
2 Small Backboards
1 Large Backboard
32 Pins
1 Vertical Middle zBoard
pin hole on both sides
4 Vertical side zBoards
pin hole on one side
1 Top Horizontal zBoard
4 pin holes
1 Middle Horizontal zBoard
pin holes on top and bottom
1 Bottom Horizontal zBoard
10 pins holes
WARNING: CHOKING HAZARD
Small parts NOT for children under 3 years
Included
CUBBY ORGANIZER
Help and Comments www.waybasics.com/contact
version 042017
• Assemble your unit on a flat even surface
• Make sure zBoard surfaces are clean and dry
• When moving your Way Basics unit, lift from the bottom
• Indoor use only. Not in bathroom.
CAUTION placing unit on its side or back
will compromise structural integrity. Use
right side up.