Instructions / Assembly

Watch and Assemble www.waybasics.com/help-tribeca Help and Comments www.waybasics.com/contact Share and Win www.waybasics.com/share
Important
Tip Start assembly from bottom to top.
DO NOT place unit on its side or back as
it will compromise its structural integrity.
THIS SIDE UP
1 2 3
4
5 6 7 8
Carefully remove the 3M
protective layer from adhesive.
Place alignment pins
in vertical zBoards.
Align middle vertical zBoard
to horizontal zBoard
(grooves on 2 sides).
Align backer boards to
horizontal zBoard as shown.
Arrange vertical zBoard with
grooves facing backboard
as shown.
Repeat steps 1 - 6 for next tier. Finish last tier then align
horizontal zBoard and press
firmly to secure unit together.
Visit links below for more details.
Enjoy building possibilities!
Align middle zBoard
(grooves on 2 sides).
6 Backer Boards
thin and has no adhesive
2 Horizontal zBoards
groove on 1 side
6 Vertical zBoards
groove on 1 side
36 Pins
2 Middle
Horizontal zBoards
grooves on 2 sides
WARNING: CHOKING HAZARD
Small parts NOT for children under 3 years
3 Middle
Vertical zBoards
grooves on 2 sides
Included
TRIBECA BOOKCASE
• Assemble your unit on a flat even surface, carpet not recommended
• Furniture is for indoor use only
• When moving your Way Basics furniture, lift from the bottom
• Make sure zBoard surfaces are clean and dry