Instructions / Assembly

Watch and Assemble www.waybasics.com/help-tribeca Help and Comments www.waybasics.com/contact Share and Win www.waybasics.com/share
Important
Tip Start assembly from bottom to top.
DO NOT place unit on its side or back as
it will compromise its structural integrity.
THIS SIDE UP
1 2 3 4
5 6 7 8
Carefully remove the 3M
protective layer from adhesive.
Place alignment pins
in vertical zBoards.
Align vertical zBoards, middle
vertical zBoard and backer
board to horizontal zBoard
(grooves on 1 side).
Align middle zBoard
(grooves on 2 sides).
Align vertical zBoards, middle
vertical zBoard and backer
board to horizontal zBoard.
Align middle zBoard
(grooves on 2 sides).
Align vertical zBoards, middle
vertical zBoard and backer
board to horizontal zBoard.
Align horizontal zBoard. Visit
links below for more details.
Enjoy building possibilities!
6 Backer Boards
thin and has no adhesive
2 Horizontal zBoards
groove on 1 side
6 Vertical zBoards
groove on 1 side
36 Pins
2 Middle
Horizontal zBoards
grooves on 2 sides
WARNING: CHOKING HAZARD
Small parts NOT for children under 3 years
3 Middle
Vertical zBoards
grooves on 2 sides
Included
TRIBECA BOOKCASE
• Assemble your unit on a flat even surface, carpet not recommended
• Furniture is for indoor use only
• When moving your Way Basics furniture, lift from the bottom
• Make sure zBoard surfaces are clean and dry