Owner's Manual

ManualsBrandsWavtech ManualsCar Audio ProcessorsWavtech 2-Channel Line Driver

www.wavtech-usa.com

Owner’s Manual

2-Channel LOC / Line Driver

Auto Turn-On

Paragraphic EQ

Remote Level Control

Summary of content (8 pages)

PAGE 1
2-Channel LOC / Line Driver Paragraphic EQ Ÿ Auto Turn-On Ÿ Remote Level Control Owner’s Manual www.wavtech-usa.
PAGE 2
WARNING CAUTION This symbol means important instructions. Failure to heed them can result in serious injury or death. This symbol means important instructions. Failure to heed them can result in injury or property damages. WARNING • DO NOT DRIVE WHILE DISTRACTED. Any function that requires your prolonged attention should not be performed while driving. Always stop the vehicle in a safe location before performing any such function. Failure to do so may result in an accident.
PAGE 3
Introduction Welcome to Wāvtech, exceptional mobile audio integration products for audiophiles. Our products are engineered to provide a truly remarkable listening experience. Built for the professional installer, our OEM integration and signal processor models are simply the best solution available for unlimited sound system upgrades while retaining the factory receiver.
PAGE 4
Œ Œ RCA Input Jacks: Ž Ž For left and right channel low level (a.k.a. line level) signal connections to the source unit. Input signals ranging from 0.5Vrms to 5Vrms will produce up to 10Vrms RCA output at maximum to minimum gain. These inputs are diﬀerential, but may be set to unbalanced via internal jumpers (labeled BAL/UNBAL) if required for a particular source or to reduce coupled noise if left ﬂoating.
PAGE 5
System Examples Example-1: Speaker Level Input from OEM Radio +12V GND REM OUT SPK IN RCA OUT RLC Note: When using a factory receiver’s internal power IC to drive speakers directly and provide signal to the linkQ, note that these speaker level outputs will likely clip below the maximum volume setting. Adjust gain accordingly for optimum unclipped volume range and system output.
PAGE 6
Speciﬁcations Frequency Response Input Impedance Input Sensitivity Max Input Voltage Output Impedance Max Output Voltage THD+N S/N Paragraphic EQ Remote Level Control Turn-On Trigger Remote Output Current Draw Operating Voltage Max Flat (+0/-1dB) Extended (+0/-3dB) Spk Input RCA Input Spk Input (max-min gain) RCA Input (max-min gain) peak, <5sec cont.
PAGE 7
Installation Notes Vehicle Description Ÿ Year, Make, Model: Ÿ Trim Level / Package: OEM Audio System Info Ÿ Head Unit (type, BT/AUX in, etc.): Ÿ Speakers (size/location, etc.): Ÿ Subwoofer(s) (size/location, etc.): Ÿ Ampliﬁer(s) (location, output voltage, etc.): Ÿ Other: linkQ Connections & Settings Ÿ Installed Location: Ÿ Wiring (connection locations, signal type, turn-on mode, etc): Ÿ Settings (gain, max master vol, crossover, etc.