2-Channel LOC / Line Driver 10Vrms Output Ÿ Auto Turn-On Ÿ OEM Load Detect Compatible Owner’s Manual www.wavtech-usa.
WARNING CAUTION This symbol means important instructions. Failure to heed them can result in serious injury or death. This symbol means important instructions. Failure to heed them can result in injury or property damages. WARNING • DO NOT DRIVE WHILE DISTRACTED. Any function that requires your prolonged attention should not be performed while driving. Always stop the vehicle in a safe location before performing any such function. Failure to do so may result in an accident.
CAUTION • STOP USE IMMEDIATELY IF A PROBLEM OCCURS. Failure to do so may result in personal injury or damage to the product. Return it to your authorized Wāvtech dealer. • HAVE AN EXPERT DO THE WIRING AND INSTALLATION. This unit requires special technical skill and experience for wiring and installation. To insure safety and proper function, always contact the authorized dealer where you purchased the product to have it done professionally. • INSTALL THE UNIT SECURELY WITH SPECIFIED PARTS.
Introduction Welcome to Wāvtech, exceptional mobile audio integration products for audiophiles. Our products are engineered to provide a truly remarkable listening experience. Built for the professional installer, our OEM integration and signal processor models are simply the best solution available for unlimited sound system upgrades while retaining the factory receiver.
Ž Power Supply Terminal: ‘ ’ “ ” For +12V battery, chassis ground, remote in and remote output wire connections. A minimum of 18AWG wire is recommended for power and ground connections. Always protect the +12V power wire with a 1-amp fuse. Speaker Level Input Terminal: For left and right channel speaker level (a.k.a. high level) connections to the source. Input signals ranging from 2Vrms to 20Vrms will produce up to 10Vrms RCA output from maximum to minimum gain.
Installation & System Wiring It is important to read this manual thoroughly before starting your installation and always plan accordingly. Before installing any Wāvtech product, disconnect the negative (ground) wire from the vehicle’s battery to avoid damage to the vehicle or yourself. Following all guidelines will help provide years of enjoyment with your Wāvtech linkD audio interface.
Remote Output (REM OUT): Use the remote output to provide a +12V trigger to turn on amplifiers or other aftermarket devices. This +12V output is generated internally by the interface when turned on either by REM IN or automatic sensing, and will provide over 500mA of continuous current for external devices.
Example-3: RCA Input from Aftermarket Radio REM IN +12V GND RCA OUT RCA IN REM OUT Note: When using a receiver’s internal power IC to drive speakers directly and its RCA outputs to the linkD for external amplifiers, note that speaker outputs will usually clip at a lower volume level than RCA outputs. Adjust gain settings accordingly for matched unclipped volume range.
Specifications Frequency Response Input Impedance Input Sensitivity Max Input Voltage Output Impedance Max Output Voltage THD+N S/N Turn-On Trigger Remote Output Current Draw Operating Voltage Product Dimensions Max Flat (+0/-1dB) Extended (+0/-3dB) Spk Input RCA Input Spk Input (max-min gain) RCA Input (max-min gain) Spk Input peak, <5sec cont. <10Hz to >75kHz <10Hz to >100kHz 180Ω 20kΩ 2-20Vrms / 4-40Vrms 0.
Installation Notes Vehicle Description Ÿ Year, Make, Model: Ÿ Trim Level / Package: OEM Audio System Info Ÿ Head Unit (type, BT/AUX in, etc.): Ÿ Speakers (size/location, etc.): Ÿ Subwoofer(s) (size/location, etc.): Ÿ Amplifier(s) (location, output voltage, etc.): Ÿ Other: linkD Connections & Settings Ÿ Installed Location: Ÿ Wiring (connection locations, signal type, turn-on mode, etc): Ÿ Level Settings (gain position, max master vol, etc.
Warranty & Service Care Wāvtech warrants this product to be free from defects in material and workmanship for a period of one (1) year when purchased from an authorized Wāvtech retailer within the United States. This warranty will be extended to a period of two (2) years when the installation is performed by an authorized Wāvtech retailer. A valid sales receipt is required to verify eligibility of purchase and installation.
v0718 Wāvtech® 7931 E. Pecos Rd Suite 113 Mesa, AZ 85212 (480) 454-7017 ©Copyright 2018 Wāvtech, LLC. All Rights Reserved.
