Owner's Manual
&WARNING
This symbol means
important
instructions.
Failure
to
heed them
can
result in serious injury
or
death.
&CAUTION
This symbol means
important
instructions.
Failure
to
heed them can result in
injury
or
property
damages.
&wARNINCi
•
DO
NOT
DRIVE WHILE DISTRACTED. Any function
that
requires
your
prolonged
attent
ion should
not
be performed
while driving. Always stop
the
vehicle in a safe location before
perform
i
ng
any such function. Failure
to
do
so
may
result in
an
accident.
• KEEP THE
VOLUME
AT MODERATE LEVELS WHILE
DRIVING.
Excess
volume levels
can
obscure sounds such
as
emergency vehicle sirens
or
road warning signals and may result in
an
accident. Continuous exposure
to
high sound
pressure levels may cause permanent hearing loss. Use common sense and practice safe sound.
• FOR USE
WITH
12V
NEGATIVE GROUND VEHICLE APPLICATIONS ONLY. Using this product
other
than in its
designed application may result in fire, injury
or
product damage.
• MAKE
THE
CORRECT WIRING CONNECTIONS
AND
USE PROPER FUSE PROTECTION. Failure
to
connect wiring
correctly
or
use appropriate fuse protection
may
result in fire, injury
or
product damage. Ensure
proper
fusing
of
all
system
power
wiring and install a 1-ampere in-line fuse
(not
included)
with
the
+1
ZV
lead
to
the
unit's
power
supply
connector.
• DISCONNECT
THE
NEGATIVE BATTERY
TERMINAL
BEFORE INSTALLATION. Failure
to
do
so may result in fire,
injury
or
damage
to
the
unit
.
•
DO
NOT
ALLOW CABLES TO BECOME ENTANGLED
IN
SURROUNDING OBJECTS. Arrange wiring and cables
to
prevent obstructions when driving. Cables
or
wiring
that
obstruct
or
hang up on places such
as
steering wheel, brake
pedals, etc.
can
be extremely hazardous.
•
DO
NOT
DAMAGE VEHICLE SYSTEMS
OR
WIRING WHEN DRILLING HOLES. When drilling holes in
the
chassis
for
installation, take precautions so
as
not
to
contact, puncture
or
obstruct
brake lines, fuel lines, fuel tanks, electrical
wiring, etc. Failure
to
take such precautions may result in fire
or
an
accident.
•
DO
NOT
UTILIZE OR CONNECT TO
ANY
PART
OF
VEHICLE SAFETY SYSTEMS. Bolts, nuts
or
wires used in
the
brake, airbag, steering
or
any
other
safety-related systems
or
fuel tanks should
NEVER
be used
for
mounting,
power
or
ground connections. Using such parts may disable control
of
the
vehicle
or
result in fire.
&cAUTION
• STOP USE IMMEDIATELY IF A PROBLEM OCCURS. Failure
to
do
so may result in personal injury
or
damage
to
the
product. Return
it
to
your
authorized Wavtech dealer.
• HAVE
AN
EXPERT
DO
THE
WIRING
AND
INSTALLATION. This
un
it requires special technical skill and experience
for
wiring and installation.
To
insure safety and proper function, always contact
the
authorized dealer where you
purchased
the
product
to
have
it
done professionally.
• INSTALL
THE
UNIT
SECURELY
WITH
SPECIFIED PARTS.
Be
sure
to
use only the included parts and specified
installation accessories
(not
included).
Use
of
other
than designated parts may damage this
unit
. Install
the
unit
securely so
that
it
will
not
come loose during a collision
or
sudden
jolt.
• ROUTE WIRING AWAY FROM SHARP EDGES
AND
MOVING
PARTS. Arrange cables and wiring away
from
sharp
or
pointed edges and avoid moving parts such
as
seat hinges
or
rails
to
prevent pinching
or
wear.
Use
loom
protection
where appropriate and always use a
grommet
for
any wiring routed through metal.
• NEVER RUN SYSTEM WIRING OUTSIDE OR UNDERNEATH
THE
VEHICLE. All wiring must be routed, secured and
protected inside
the
vehicle. Failure
to
do so may result in fire, injury
or
property
damage.
• INSTALL
THE
UNIT
IN A DRY
AND
VENTILATED LOCATION. Avoid mounting locations where
the
unit
will
likely be
exposed
to
high moisture
or
heat
without
adequate ventilation. Moisture penetration
or
heat buildup may result in
product failure.
• REDUCE GAIN
AND
SOURCE
VOLUME
TO
MINIMUM
LEVELS FOR
INITIAL
SYSTEM
TUNING
AND
BEFORE
CONNECTION
TO
AN
AMPLIFIER. Ensure amplifier power is
off
before connecting
RCA
cables and
follow
proper
system gain setting procedure. Failure
to
do
so
may result in damage
to
the amplifier and/or connected components.
Package Contents:
Main
Unit
Terminals
---
----
ff
Ty
PWR
/SPK
GND
Mounting Tabs
(detachable)
ww
1
Remote Level Control
Remote Cable
(16.
4ft
/
Sm
)
~
Accessories Required
for
Installation
(not
included):
•
RCA
Interconnects
• 18AWG Wire
• In-line
Fuse
Holder
w/1A
fuse
• Battery Ring Terminal
• Wire Crimp Connectors
• Grommets and Loom
• Cable Ties
•
Mount
ing Screws