Owner's Manual
Lt WARNING
This symbol means
important
instructions.
Failure
to
heed them
can
result in serious injury
or
death.
Lt CAUTION
This symbol means
important
instructions.
Failure
to
heed them
can
result in injury
or
property
damages.
~
WARNING
•
DO
NOT
DRIVE WHILE DISTRACTED. Any function
that
requires
your
prolonged
attention
should
not
be performed
while driving. Always stop the vehicle in a safe location before performing any such function. Failure
to
do
so may
result in
an
accident.
• KEEP THE
VOLUME
AT
MODERATE LEVELS WHILE DRIVING.
Excess
volume levels
can
obscure sounds such
as
emergency vehicle sirens
or
road warning signals and may result in
an
accident. Continuous exposure
to
high sound
pressure levels may cause permanent hearing loss.
Use
common sense and practice safe sound.
• FOR USE WITH
12V
NEGATIVE GROUND VEHICLE APPLICATIONS
ONLY
. Using this product
other
than in
its
designed application may result in fire, injury
or
product damage.
•MAKE
THE CORRECT WIRING CONNECTIONS
AND
USE
PROPER
FUSE
PROTECTION. Failure
to
connect wiring
correctly
or
use appropriate fuse protection may result in fire, injury
or
productdamage. Ensure proper fusing
of
all
system power wiring and install a 1-ampere in-line fuse
(not
included)
with
the +12V lead
to
the unit's
power
supply
connector.
• DISCONNECT THE NEGATIVE BATTERY TERMINAL BEFORE INSTALLATION. Failure
to
do
so
may result in fire,
injury
or
damage
to
the unit.
•DO
NOT
ALLOW CABLES
TO
BECOME ENTANGLED
IN
SURROUNDING OBJECTS. Arrange wiring and cables
to
prevent obstructions when driving. Cables
or
wiring
that
obst
ruct
or
hang up on places such
as
steering wheel, brake
pedals, etc.
can
be extremely hazardous.
•
DO
NOT
DAMAGE VEHICLE SYSTEMS OR WIRING WHEN DRILLING HOLES. When drilling holes in the chassis
for
installation, take precautions
so
as
not
to
contact, puncture
or
obstruct
brake lines, fuel lines,
fuel
tanks, electrical
wiring, etc. Failure
to
take such precautions may result in
fire
or
an
accident.
•
DO
NOT
UTILIZE OR CONNECT
TO
ANY
PART OF VEHICLE SAFETY SYSTEMS. Bolts, nuts
or
wires used in the
brake, airbag, steering
or
any
other
safety-related systems
or
fuel tanks should
NEVER
be used
for
mounting,
power
or
ground connections. Using such parts may disable
control
of
the
vehicle
or
result in fire.
~CAUTION
• STOP
USE
IMMEDIATELY IF A PROBLEM OCCURS. Failure
to
do
so may result in personal injury
or
damage
to
the
product. Return
it
to
your
authorized Wavtech dealer.
•
HAVE
AN
EXPERT
DO
THE WIRING
AND
INSTALLATION. This unit requires special technical skill and experience
for
wiring and installation. To insure safety and proper function, always contact the authorized dealer where you
purchased the
product
to
have
it
done professionally.
• INSTALL THE
UNIT
SECURELY WITH SPECIFIED PARTS. Be sure
to
use only the included parts and specified
installation accessories
(not
included).
Use
of
other
than designated parts may damage this
unit
. Install the
unit
securely
so
that
it
will
not
come loose during a collision
or
sudden
jolt.
• ROUTE WIRING
AWAY
FROM SHARP EDGES
AND
MOVING
PARTS. Arrange cables and wiring away
from
sharp
or
pointed edges and avoid moving parts such
as
seat hinges
or
rails
to
prevent pinching
or
wear. Use loom protection
where appropriate and always use a
grommet
for
any wiring routed through metal.
• NEVER RUN SYSTEM WIRING OUTSIDE OR UNDERNEATH THE VEHICLE.
All
wiring must be routed, secured and
protected inside the vehicle. Failure
to
do
so
may result in fire, injury
or
property
damage.
• INSTALL THE
UNIT
IN
A DRY
AND
VENTILATED LOCATION. Avoid mounting locations where the
unit
will
likely be
exposed
to
high moisture
or
heat
without
adequate ventilation. Moisture penetration
or
heat
buildup may result in
product failure.
• REDUCE GAIN
AND
SOURCE VOLUME
TO
MINIMUM
LEVELS FOR INITIAL SYSTEM TUNING
AND
BEFORE
CONNECTION
TO
AN
AMPLIFIER. Ensure amplifier
power
is
off
before connecting
RCA
cables and
follow
proper
system gain setting procedure. Failure
to
do
so
may result in damage
to
the amplifier
and/or
connected components.
Package Contents:
Main Unit
busfltEQ
1
Terminals
PWR/SPK
GND
Mounting Tabs
(detachable)
l
()
,)J
.2.J
\.
2.
Remote Level Control
Remote Cable
(16
.4ft
/ Sm)
-S'
- 1
"f:-
-'l
~~
rn
Accessories Required
for
Installation
(not
included):
•
RCA
Interconnects
• 18AWG Wire
• In-line
Fuse
Holder
w/1A
fuse
Battery Ring Terminal
• Wire Crimp Connectors
• Grommets and Loom
• Cable Ties
Mounting Screws