bassFREQ Bass Processor/ LOC / Line Driver Parametric EQ • 24dB/Oct Crossover • Remote Level Control Owner's Manual bassFREQ □8 □8 □8 □8 ~ 0 □ □ □ □ 8 8 8 8 I ll wavtech ~ - PARAMETRIC EQ O CLIP I ® GAIN BOOST WIDTH d) ffi 0 (dB) 12 NAR WIDE ~ FREQ I C CROSSOVER~ ~ SUBSONIC ± i 30 (Hz) 80 5 (Hz) 40 LPF l]) 50 0 (Hz) 400 )) www.wavtech-usa.
Lt WARNING Lt CAUTION This symbol means important instructions. Failure to heed them can result in serious injury or death. This symbol means important instructions. Failure to heed them can result in injury or property damages. ~ WARNING • DO NOT DRIVE WHILE DISTRACTED. Any function that requires your prolonged attention should not be performed while driving. Always stop the vehicle in a safe location before performing any such function. Failure to do so may result in an accident.
Introduction Welcome to Wavtech, exceptional mobile audio integration products for audiophiles. Our products are engineered to provide a truly remarkable listening experience. Built for the professional installer, our OEM integration and signal processor models are simply the best solution available for unlimited sound system upgrades while retaining the factory receiver. Features • Bass Enhancement Processor · Fully Adjustable Parametric EQ · Variable Low Pass Filter (-24dB/Oct.
Installation & System Wiring It is important to read this manual thoroughly before starting your installation and always plan accordingly. Before installing any Wavtech product, disconnect the negative (ground) wire from the vehicle's battery to avoid damage to the vehicle or yourself. Following all guidelines will help provide years of enjoyment with your Wavtech bassFREQ audio interface.
Example-3: RCA Input from Aftermarket Radio GND REM OUT Note: Other devices such as smartphones or MP3 players may also be used as the main system source via the RCA input, which typically produce 1Vrms output or less. While the bassFREQ's auto turn-on circuit will detect very low signal levels, it may be necessary in some cases to adjust gain for reasonable listening levels but with reduced master volume range.
&crossover: This section is for selecting the cut-off frequencies for the low-pass filter (LPF) and subsonic filter (a.k.a. infrasonic or high-pass). 0Subsonic: Provides adjustment of the lower F cut-off point below which all frequencies are filtered out at -24dB/oct. Very low freqencies can waste amplifier power and damage subwoofers. This adjustment is especially important for ported enclosures to prevent over-excursion below the tuning frequency.
Installation Notes Vehicle Description • Year, Make, Model: _ __ _ _ _ _ _ _ _ __ _ _ __ _ _ _ _ _ _ _ __ _ _ _ __ • Trim Level/ Package:_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ __ _ _ _ __ _ _ __ OEM Audio System Info • Head Un it (type, BT/AUX in, etc.): _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ __ • Speakers (size/location, etc.): - - - - -- - - - - - - - -- - - - - - - - - - - - - • Subwoofer(s) (size/location, etc.
v0418 WavtechTM 7931 E. Pecos Rd Suite 113 Mesa, AZ 85212 {480) 454-7017 ©Copyright 2018 Wavtech, LLC. All Rights Reserved.
