Manual

ManualsBrandsWavtech ManualsCar Audio ProcessorsWavtech Bass Enhancement Processor

www.wavtech-usa.com

Owner’s Manual

Bass Processor / LOC / Line Driver

Parametric EQ

24dB/Oct Crossover

Remote Level Control

Summary of content (8 pages)

PAGE 1
Bass Processor / LOC / Line Driver Parametric EQ Ÿ 24dB/Oct Crossover Ÿ Remote Level Control Owner’s Manual www.wavtech-usa.
PAGE 2
WARNING CAUTION This symbol means important instructions. Failure to heed them can result in serious injury or death. This symbol means important instructions. Failure to heed them can result in injury or property damages. • DO NOT DRIVE WHILE DISTRACTED. WARNING Any function that requires your prolonged attention should not be performed while driving. Always stop the vehicle in a safe location before performing any such function. Failure to do so may result in an accident.
PAGE 3
Introduction Welcome to Wāvtech, exceptional mobile audio integration products for audiophiles. Our products are engineered to provide a truly remarkable listening experience. Built for the professional installer, our OEM integration and signal processor models are simply the best solution available for unlimited sound system upgrades while retaining the factory receiver. Features Ÿ Bass Enhancement Processor Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ Ÿ Fully Adjustable Parametric EQ Variable Subsonic Filter (-24dB/Oct.
PAGE 4
Installation & System Wiring It is important to read this manual thoroughly before starting your installation and always plan accordingly. Before installing any Wāvtech product, disconnect the negative (ground) wire from the vehicle’s battery to avoid damage to the vehicle or yourself. Following all guidelines will help provide years of enjoyment with your Wāvtech bassFREQ audio interface.
PAGE 5
Example-3: RCA Input from Aftermarket Radio +12V RLC REM IN GND RCA IN RCA OUT REM OUT Note: Other devices such as smartphones or MP3 players may also be used as the main system source via the RCA input, which typically produce 1Vrms output or less. While the bassFREQ’s auto turn-on circuit will detect very low signal levels, it may be necessary in some cases to adjust gain for reasonable listening levels but with reduced master volume range.
PAGE 6
’ Crossover: This section is for selecting the cut-oﬀ frequencies for the low-pass ﬁlter (LPF) and subsonic ﬁlter (a.k.a. infrasonic or high-pass). “ Subsonic: Provides adjustment of the lower cut-oﬀ point, below which all frequencies are ﬁltered out at -24dB/Oct. Very low freqencies can waste ampliﬁer power and damage subwoofers. This adjustment is especially important for ported enclosures to prevent over-excursion below the tuning frequency.
PAGE 7
Installation Notes Vehicle Description Ÿ Year, Make, Model: Ÿ Trim Level / Package: OEM Audio System Info Ÿ Head Unit (type, BT/AUX in, etc.): Ÿ Speakers (size/location, etc.): Ÿ Subwoofer(s) (size/location, etc.): Ÿ Ampliﬁer(s) (location, output voltage, etc.): Ÿ Other: bassFREQ Connections & Settings Ÿ Installed Location: Ÿ Wiring (connection locations, signal type, turn-on mode, etc): Ÿ Settings (gain, max master vol, crossover, etc.