User manual

Appendix: Quick Start Guide to Wavion WS410
96 Wavion
1. To allow entry of a new IP address, select Static from the Configured Boot Protocol
dropdown list.
2. In the Configured IP Address field, enter the required IP address.
Setting the System Management Configuration
You can decide to allow system management from the Wireless Interface, or to allow
management only from the Ethernet Interface, for security purposes.
To enable or disable system management from the Wireless Interface
In the System Management Configuration area, in the Management from Wireless field, from
the dropdown list, select Enabled to allow system management from the wireless interface,
or Disabled to restrict system management to the Ethernet Interface.
Saving Changes
To have changes remain in effect
1.
Click Apply.
2. Click Save.
Return to the Home page from the menu bar to continue with the quick start procedure.
Changing the Network Interface Configuration
From the Home page, in the Network Interfaces area, click Switched 802.11 b/g. (You can
also get to this page from the Network Interfaces item on the menu.)
The Switched 802.11 b/g page is displayed.
NOTE: The system must be rebooted for these changes to take effect; for the
quick start, you are instructed to reboot after the quick start procedure is
completed.
NOTE: After making changes on a page, you must click both Apply and Save,
or the changes do not remain in effect after the next reboot.