User manual

Managing System and Station Security
72 Wavion
6. In the Rename SSID field, enter an SSID Name to be used in Probe Responses.
7. Check the SSID Enabled checkbox. This enables the SSID.
8. Configure all security parameters: Mode, Authentication, and Encryption as required. See
on page 76. Keys are added in the Related VLAN section below.
9. Within the Related VLANs edit the VLAN Name and VLAN ID.
10.Edit the VLANSs specific security parameters that are related to the SSID Security
definition.
11.Make sure the VLAN and SSID are enabled by marking the VLAN Enabled and SSID
enabled checkbox respectively.
12.Click Apply.
Figure 6.13. Editing SSID Adding VLAN WEP
NOTE: Only the Primary SSID (the first SSID) is advertised in Beacons. These
additional SSIDs are hidden SSIDs.