User manual

Managing System and Station Security
Rev 1.1.0 User Manual 69
VLAN Introduction and Configuration
Tagging VLANs
While on the Wireless media the VLANs are identified by different broadcast keys, on the
Ethernet interface they are identified by tags. The VLAN tag is added following the
Ethernet header.
The default VLAN has the VLAN ID equal to 1. All management traffic to and from WS410
is on this VLAN, however, the traffic that leaves the unit is untagged. The backhaul device
(switch or router) is configured to pass all VLANs on the port to WS-410, and VLAN 1 is
the default VLAN for this port.
Configuring VLANs
To configure a VLAN
1.
Click Security from the menu bar.
The Security page displays.
2. Click VLANs Mode to enter VLAN mode . A popup asks if you are sure about the move;
click OK.
The Security page appears in VLANs mode (See figure 6.9 below).
Figure 6.9. Security Page in VLANs Mode