User manual

Managing System and Station Security
Rev 1.1.0 User Manual 57
To change a password
1.
In the HTTP/CLI Users section, select the user name for which you want to change the
password in the username dropdown box.
2. Enter a new password in the New Password field. A password contains at least 6
characters.
3. Re-enter the new password in the Confirm Password field.
4. Click Apply.
Confirmation pop-up box is displayed.
5. Click OK.
6. Click Save for the password change to remain after a reboot.
To add a new user to the system
1.
In the HTTP/CLI Users section, select (new) from the User Name dropdown list.
A New User field appears.
2. Enter a new user name in the field.
3. Select a user type from the user type dropdown list, either Administrator or Viewer.
HTTP Configuration Use this section to enable secure browsing
by creating an SSL certificate
See below
Enable Secure Browsing
(SSL only)
If the checkbox is marked, it indicates
Secure Browsing (SSL) is enabled, and
non-secured browsing is disabled.
Create new SSL
certificate (using the
following identifiers
If the checkbox is marked a new SSL
certificate will be created using the
following identifiers:
System Name An administratively-assigned name for this
managed node.
Domain Name An administratively-assigned node’s
domain name.
Options Click buttons in this section with respect to
changes made in the HTTP Configuration
section
Apply Click to have changes take effect
temporarily
Save (on menu bar) Click to have changes made on this page
remain even after a reboot.
Cancel Click to clear changes made; Cancel only
works on changes where neither Save or
Apply was clicked
Table 6.2. Management Configuration page
Field Description