User manual

Managing Network Interfaces
42 Wavion
Scan Configuration The scan sensitivity. the values can be:
• Static Low Interference: Highest
scan sensitivity
• Static Moderate Interference
• Static High Interference: Lowest
scan sensitivity
The default is Static Low Interference.
Using lower sensitivity scan will not
monitor the weak interference and show
only the high power activity.
Initial channel The channel in which the system perform
the calibration before scanning. Scan
results are more accurate if initial channel
has low interference level.
Automatic set to
recommended channel
and reboot
• Check Box = The system will reboot
to the recommended channel after
scanning.
• Un-Check Box = The system will
scan and display the recommended
channel but will stay in scan mode
(for further scanning or for manual
selection of desired channel)
Scan results Results of the scanning
Scan Status Status of the system mode.
• Not in ACS mode - is shown during
operational mode
• Scanning - is shown during scan
• Finished scanning - is shown after
scanning if the “Automatic set to
recommended channel and reboot is
not set
Recommended channel The best channel that was chosen based
on scan results. It selects the best channel
from channels selected in the “available
channel” list. the recommended channel
incorporates both noise level and channel
activity in the selection.
Table 4.4. Automatic Channel Selection page
Field Description