User manual

Managing the System Configuration
Rev 1.1.0 User Manual 21
4. In the Configured Subnet Mask, enter a valid netmask.
Setting the System Management Configuration
You can decide to allow system management from the Wireless Interface, or to allow
management only from the Ethernet Interface, for security purposes.
To enable or disable system management from the Wireless Interface
In the System Management Configuration area, in the Management from Wireless field, from
the dropdown list, select Enabled to allow system management from the wireless interface,
or Disabled to restrict system management to the Ethernet Interface.
Saving Changes
1. Click Apply.
2. Click Save.
Managing System and Software Configurations
You can change both the system startup configuration and upgrade the software version
from the system software tabs.
To access the system software tabs
• Click System Software from the menu, as a sub-item of the System menu item.
The system software tabs display, consisting of the Software Upgrade tab for managing
the system software version, and the System Configuration tab for managing the system
configuration.
Performing Software Upgrades
The Software Upgrade tab shows details about the current software version, and allows you
to set properties required to install a new software version. It is also possible to return to the
factory default software, backup the current version of the software, and return to a
previously backed up version of the software.
NOTE: The system must be rebooted for these changes to take effect.
NOTE: After making changes on this page, you must click both Apply and
Save, or the changes do not remain in effect after the next reboot.