User manual

Managing the System Configuration
20 Wavion
This page contains basic static information on the system, such as contact details, and IP
addresses. Several changes are recommended on this page.
Setting System Contact Details
In the System Identity area, in the System Contact field, enter the contact email address of
the net owner.
Setting the IP Address Configuration
Change the IP address to allow the full configuration. The Current IP Address Configuration
area lists a default IP address; it is possible to perform initial testing with this address, but it
is highly recommended to change the IP address.
To change the IP address
In the Configured IP Address Configuration section,
1. For a DHCP obtained address, select DHCP. Following a reboot, the WS410 will
automatically obtain and IP address, Subnetwork, and Default Gateway from the DHCP
server.
2. To allow entry of a new IP address, select Static from the Configured Boot Protocol
dropdown list.
3. In the Configured IP Address field, enter the required IP address.
System Management
Configuration
Management from
Wireless
• Enable -- to allow system management
from the Wireless Interface
• Disable -- to allow management only
from the Ethernet Interface
Options
Apply Click to have changes take effect
temporarily
Save (on left side of
screen)
Click to have changes made on this page
remain even after a reboot; some changes
also require reboot to take effect
Reboot Be sure to click Save first if you made
changes you wish to persist after reboot.
Click Reboot to have all saved changes
take effect
Cancel Click to clear changes made; Cancel only
works on changes where neither Save or
Apply was clicked
Table 3.1. System Configuration page
Field Description