User manual

Using the WS410 Web-based Management Interface
Rev 1.1.0 User Manual 13
Saving Data
In the WS410, applying data changes to take effect is a process consisting of several steps.
To affect a change in a data field
1.
Edit the data in the field or make a selection.
2. Click Apply in the bottom right of the window.
When you click Apply, the Web browser shows that the page is busy. Usually, this is shown
in the bottom status bar of the browser by an expanding set of green boxes. It is
necessary to let this cycle complete before doing anything else.
3. In some cases the Apply is sufficient and rebooting is not necessary to make the change
effective.
4. In some cases, a Reboot is necessary to put the changes into effect. Click Save before the
Reboot.
Example of a Necessary Save and Reboot
Figure 1.5. Example Save and Reboot Warning
In the above example you need to click Save to effect the changes. See an example of the
Save button in Figure 1.5 above.
Click Save after making and applying changes.
NOTE: You must click Apply before navigating to another page or the changes
do not take effect.
NOTE: If you want the change to be effective following a reboot, you must
click Save, otherwise the changes are lost after the reboot.