Instruction manual

WBSn-2400 Quick Start Guide Page 8
2. Slide the steel bands into the appropriate side slots of the post clamp.
Note: For a thinner post, the steel bands should be threaded through the inner slots, and for a wider
post, through the outer slots.
3. Attach the post-clamp to the post, and close and tighten the steel bands.
4. If you are installing the WBSn-2400-S on a vertical post, attach the WBSn-2400-S unit to the post-
clamp, with the screws and washers. Tighten the screws using a ratchet key, set at 13 mm, and proceed
to Step 6.
5. If you are installing WBSn-2400-SCT on a horizontal post, select the direction in which the base station
unit should point on the horizontal plane prior to continuing with the installation.
6. Once you have determined the correct direction, connect the two extenders to the post clamp.
Attach the WBSn-2400-SCT base station unit and connected extenders to the base station unit.
WBSn attached with extenders
7. As you tighten the screws, verify that the tilt and direction of the base station unit are correct for the
coverage area required.
Note: In an urban setting, with a high-placed installation, a slight downwards tilt (approximately 8-10
degrees) will help reduce noise and interference.
8. For extra security, thread the iron cable through the corner hole on the post-clamp, and the middle hole
on the WBSn-2400-SCT unit, securing it with the Caribena provided.
Note: This will provide extra physical security for the WBSn-2400-SCT unit.
Wind Loading Considerations
The Wavion WBSn-2400 weighs between approximately four kilograms, including all mounting hardware.
When the Wavion WBSn-2400 is mounted on a pole, the sail area of the WBSn-2400 is approximately 0.11
m
2
. The Wavion WBSn-2400 can load a pole with a maximum load of 3400 Newton in wind conditions of 264
km/h (165 mph).
You should
evaluate the static and dynamic load bearing capabilities for each assembly and installation
individually.
Connecting Power and DATA
The following describes how to apply power and data to the WBSn-2400 base station.
Prior to connecting power to WBSn-2400, ensure that you have read and performed all instructions in the
pre-installation checklist.
The Wavion WBSn-2400 is equipped with two ports.
• Use the ETH port to connect the PoE cable.
• The USB port is for engineering purposes only. Ensure that the USB port is properly sealed with a
plastic cap.