Instruction manual

WBSn-2400 Quick Start Guide Page 7
Warnings
All servicing should be referred to qualified service personnel only. There are no
user-serviceable parts inside. Servicing is required when the apparatus has been
damaged in any way.
This apparatus must be properly grounded.
Do not open the unit – risk of electric shock.
Any change or modification not expressly described in this manual or approved by
the manufacturer could void your authority to operate this equipment.
The WBSn-2400 should only be installed using the antennas that were provided
as part of the original package.
A minimum distance of 40cm should be kept from the WBSn-2400 antenna when
the system is in operation.
Only UL-listed parts and components should be used for installation.
To maintain Overvoltage (Installation) Category II, install a suitable surge
suppressor device in the branch circuit to limit expected transients to Overvoltage
Category II values. The limits are based on IEC60664 and are also located in
Table 2H of UL60950 (for mains 110V, the transient rating is 1500V).
Installation and Set-up
The following section describes the installation and configuration procedures for your WBSn-2400-O or
WBSn-2400-S base station, that will enable the establishment of a basic set-up.
Further information regarding configuration procedures and information will be available in the
WBSn-2400
User Guide
.
Installing the WBSn-2400-S base station
Prior to performing the procedures described in this section, ensure that you have read all the information,
and followed all instructions and safety precautions in the Pre-Installation Checklist.
To install WBSn-2400-S:
1. Decide the manner in which the post-clamp will be attached to the post, whether horizontally or
vertically.
Note: If you wish to install WBSn-2400-S on a horizontal plane, you need to include special extenders in
your order.
Example: Horizontal post-clamp