Instruction manual

WBSn-2400 Quick Start Guide Page 13
Security Mode
Authentication Mode Encryption Mode
None Open system None
WEP
• Shared key • WEP/40
• WEP/104
WPA
• PSK (Pre-shared key)
• Radius
• TKIP
• TKIP+WEP/40
• TKIP+WEP/104
WPA2
• PSK (Pre-shared key)
• Radius
• Mixed mode PSK
• Mixed mode Radius
• Mixed mode PSK + Radius
• AES
• AES + TKIP
Radio configuration (basic)
To configure the radio settings, navigate to Configuration => Wireless => Radio. Select the required
channel bandwidth and specify the parameters, as described in the following table.
Note: Only 2.4 GHz is available for this WBSn release. 5.0 GHz will be available for future releases.
Field Description
Radio Specify that the radio waves are operational, or turn them
off for purposes such as a maintenance.
Channel/Frequency [MHz] Specify the channel/frequency
Wireless System Mode Specify the wireless system mode:
• Data
• Video Surveillance
• VOIP
• Custom
TX Power Specify the transmission power between 1-8 (where 8 is the
maximum)
VLAN configuration
1. To specify a new VLAN, navigate to Configuration => Network => Bridge.
2. Expand the VLANs Configuration window, and click Add to configure the VLAN Parameters. A pop-up
box with the following parameters is displayed.
Parameter Description and values
VLAN ID This ID should be unique and must be supported by the backbone equipment
that is connected to the WBS through the Ethernet port.
VLAN Name Edit the VLAN name as required.
Ethernet Determine whether the VLAN is configured in the Ethernet interface, and define
whether it is tagged or untagged.
VAP 1-6 Determine whether the VLAN is configured in any of the VAP interfaces and
define whether they are tagged or untagged.
3. Scroll back up to the VLANs section, and specify a VAP for the VLAN.