User manual

SSID and VLAN configuration
73 Wavion
• Click the Encryption drop down menu and select WEP in the Editing SSID page (See figure
below).
• Select from the Authentication choices either Open or Shared Key. Shared Key is
recommended.
• Select either WEP/40 or WEP/104 from the Encryption choice.
• Enter up to 4 WEP keys. Their length is dependent upon the choice selected in the step
above; WEP/40 is 10 hex characters and WPE/104 is 26 characters.
Figure 4.5 WEP Encryption
The following fields appear on the Editing SSID WEP page:
Table- 4.5 Editing SSID WEP Page
Field Description
Security Configuration
WEP Key # The key # (1-4) indicates the index of the WEP Key.
The Key value is the hexadecimal value of the WEP key as
stored in HW. For the WEP/40 this key holds 10 hexadecimal
characters, for WEP/104 this key holds 26 hexadecimal
characters.
Options
Apply Click to have changes take effect temporarily
Save (from the Menu) Click to have changes remain in effect after a reboot
Cancel
Click to clear your changes; this is only possible if Apply or
Save were not clicked