User manual

Managing the System Configuration

Rev 4.0 User Manual 18

1. Applying the VLAN parameters (external VLAN ID and tagging mode) using the

existing management traffic, and selecting the desired VLAN to be the Management

VLAN on the Administration page. After this stage the current wire-line connection

to the system GUI will drop.

2. Saving the parameters – using the new Management VLAN, i.e. over the tagged

VLAN.

To enable VLAN management

1. Apply the VLAN parameters (external VLAN ID and tagging mode) using the existing

management traffic or create a new VLAN ID.

2. Select the desired VLAN ID for the Management VLAN traffic.

3. Click Apply and Save

Note: The configuration of the Management VLAN takes effect

immediately. Therefore setting the Management VLAN is done over the

"old" VLAN (default is VLAN-1 untagged), while saving is done over the

"new" VLAN.

The 3

step in "To enable VLAN management has to be done over a

different machine/ the new VLAN.

Setting the System Management Configuration

You can decide to allow system management from the Wireless Interface, or to allow

management only from the Ethernet Interface, for security purposes.

To enable or disable system management from the Wireless

Interface

In the System Management Configuration area, in the Management from Wireless field, from

the dropdown list, select enabled to allow system management from the wireless interface, or

Disabled to restrict system management to the Ethernet Interface.

To enable or disable Startup Wizard

From the dropdown list, select “Disabled” to stop performing the Startup Wizard after each