Specifications

Page 23 – Single Com Port
Settings for the v9S Single Com Port System
Encoder Settings
The “Advanced Settings” Button will give you more Options.
Below are the “Encoder Settings” screen for the Com Ports and Protocols.
NOTE: Defaults are shown below. Fig. 14A
When Finished, Click “OK”.
Encoder Settings:
A: Protocol for the Com Port
Choices are TAP, PET and TAP, COMP1, COMP2,
WaveWare and Scope.
B: Settings for the Com Port
Choices are Verbose or Non-Verbose and Baud
Rates of 300, 1200, 2400 and 9600 with Connection
Settings of N 8, E 7 or 0 7.
C: Restore Defaults Button
Click on this Button to “Restore” Settings to
Factory Defaults.
D: Advanced Encoder Settings Button
Click on this Button to open the “Advanced” Encoder
Settings Screen for more Options. See next page.
Fig. 14A (Factory Defaults Shown)
SPS-5 v9S Single Com Port Settings Screen
For v9S Single Port System Configuration Advance Settings: (See Next Page).