Specifications

NOTE:
For most Normal Grouping of Pagers, it is “Recommended” to use a “Common” Cap Code within a Group of Pagers.
This way the Pagers within that Group will Receive the Message simultaneously, instead of paging them one at a time
from a List of Pagers, which could take awhile to go thru the entire list.
Predefined Messages
“Predefined Messages” are stored messages used for the following types of functions:
 Paging message Prefix
 Paging message Suffix
 Timer Event Triggered paging message
“Predefined Messages” can be up to 60 characters in length and the v9E Encoder can support up to 15 “Predefined
Messages”.
Encoder Settings
The v9E - “Settings” are Split into 2 Areas: “Encoder Settings” and “Advanced Encoder Settings”.
The v9E “Encoder Settings” allows Setup of the Following:
 The “Protocol” of each RS-232 Serial Com Port - TAP, WaveWare, etc.
 The “Settings” of the RS-232 Serial Com Port and Ethernet Settings
 The “Advanced Settings” Button, allows changes to Advanced Options.
The available “Advanced” v9E “Encoder Settings” Options include:
 Transmitter Duty Cycle %: 0% to 100% (Global Setting) Note: 66% is Default
 Max Messages per Batch: 10 or 32 (Global Setting) Note: 10 is Default
 Carrier Signal Detection: “On” or “Off” (Global Setting) Note: On is Default
 Carrier Detect Polarity: 0v or 5v (Global Setting) Factory Set before Shipping
 Serial Port Reset of Timed Paging: “On” or “Off”
 Assume Pager ID is Cap Code: “On” or “Off”
 Data Encoding Polarity: Normal or Inverted
 Flow Control: None, Hardware or Software
 Increment Cap Codes by 8: “On” or “Off”
 Restore Defaults Button: Resets encoder to Factory Defaults (Global Setting)
 Station ID: (Transmits site license station identifier code on a periodic basis, as required)
This Completes the “Introduction”
“Warranty and other Information” is Next…