User's Manual

USER MANUAL – ActivDuo Active RFID Tags
Configuration No. Wavetrend Technologies Ltd Master File Name Issue Date Page
00000-0000-150-1 User Manual ActivDuo Tag-00.8-UM-LT 3 DECEMBER 2008 34 OF 42
 Glass cleaner
 Clean dry cloth
7.2.2 Preparation
 Clean an area a little larger than the tag on an object. Ensure that no dust, oil, grease or residue
remains.
 Position the gel pad over the back of the tag and align the hole in the pad with the embossed circle
on the tag. Remove the gel pad cover and stick the gel pad to the back of the tag. Make sure the
hole in the pad and the circle on the back of the tag are aligned.
7.2.3 Arming the anti-tamper (if using the TA801-AT attachment kit)
 Once the gel pad is stuck firmly to the tag insert the small magnet into the pad and press around it.
Make sure the magnet has stuck firmly to the pad in the hole. The tag’s anti-tamper is now armed.
 It is recommended to place a spot of Superglue™ or other suitable adhesive on the magnet so that it
will adhere to the asset surface and be able to trigger a tamper alert more quickly should any
unauthorized attempt be made to remove a tag from its asset. Do not glue the magnet to the back of
the tag, this will prevent the anti-tamper feature from working.
7.2.4 Final steps
 Remove the other cover from the gel pad and position the tag in a suitable location on the asset.
Press firmly and ensure no air bubbles remain visible.
 The gel pad will take up to 24 hours to cure to full bond strength.
7.3 Attaching the TG801-A-WM for Tracking IT Equipment and Other Assets
7.3.1 Requirements
The Tag Attachment Kit can be used on its own to attach the TG801-A-WM tag to an asset, or can
be used together with screws and rivets. Alternatively, the tag can be attached using just screws or
rivets. The requirements below list all possible items you will need.
 TG801-A-WM tag
 4mm diameter screws or rivets (if required)
 1 adhesive gel pad (& magnet) from a 10-pack TA801 or TA801-AT Attachment Kit (if required)
 Glass cleaner
 Clean dry cloth
7.3.2 Preparation
 Clean an area a little larger than the tag on the asset. Ensure that no dust, oil, grease or residue
remains.
7.3.3 Arming the anti-tamper (if using the TA801-AT attachment kit)
 Once the gel pad is stuck firmly to the tag insert the small magnet into the pad and press around it.
Make sure the magnet has stuck firmly to the pad in the hole. The tag’s anti-tamper is now armed.