User's Guide

Link-IT “User Guide” Page 8
Version 1.03
Figure 8: Detecting Tags
Once the test is completed the Hardware Installation screen will show any tags detected
during the test as shown in Figure 1.7 below.
Figure 9: Detected Tags
User Configuration
Once passwords have been set-up and the Hardware installation completed it is necessary to
assign Tags to the User/s of the system. Prior to assigning a tag, check the Identity number of
your tag. The Tag ID is a two- part number and is printed on your tag. Refer to the Figure 1.8
Figure 10: Tag ID number
Once you have identified your tag number you can proceed with the adding of users to the
system. In the following screen (Figure 1.9) select [Add Primary User]