Operator`s manual

– 8 –
AC Volts
Ranges: 200V, 500V
Accuracy: 1.2% RDG + 10 Digits
OL Protection: 500VAC RMS/500VDC
DC Current
Ranges: 200 A, 2mA, 20mA, 200mA
Resolution: 100nA
Accuracy: 1.2% RDG + 1 Digit
Voltage Burden: 350mV max
OL Protection: .8A/250V fuse
Resistance
Ranges: 200Ω, 2kΩ, 20kΩ, 200kΩ, 2MΩ
Accuracy: 200Ω Range:
1/8% RDG + 4 Digits
Other Ranges: 1.2% RDG + 2 Digits
OL Protection: 500VAC/VDC all ranges
Diode Test
Test Current: 1.0 0.6mA
Test Voltage: 3.2VDC max
MAINTENANCE
WARNING!
To prevent electrical shock hazard, turn off the multimeter and any device
or circuit under test and disconnect the test leads before removing the
battery hatch to the rear cover.
Troubleshooting
If there appears to be a malfunction during the operation of the meter, the
following steps should be performed in order to isolate the cause of
the problem:
1. Check the battery.
2. Review the operating instructions for possible mistakes in operating
procedure.
3. Inspect and test the test probes for a broken or intermittent connec-
tion.
DM2.Man.08.00 11/29/00 8:28 PM Page 8